Difficulty

Easy

Steps

7

Time Required

                          2 minutes

Sections

2

  • Battery
  • 4 steps
  • Handheld Vacuum Power Button
  • 3 steps

Flags

0

  • BackInsignia NS-VCS14SL7

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Push down the black button to release the dust cup.
  • Pull the dust cup up and away from handheld portion to remove.

Push down the black button to release the dust cup.

Pull the dust cup up and away from handheld portion to remove.

1024

Step 2

  • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.
  • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

Step 3

  • Pull apart the red and black wires.
  • Do so for all of the wires. (Red x1, Black x2)

Pull apart the red and black wires.

Do so for all of the wires. (Red x1, Black x2)

Step 4

  • Remove the tape holding the battery to the black housing.
  • Slide the entire battery bundle out.

Remove the tape holding the battery to the black housing.

Slide the entire battery bundle out.

Step 5

              Handheld Vacuum Power Button
  • Remove motor and impeller housing to gain access to power button.

Remove motor and impeller housing to gain access to power button.

Step 6

  • Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.

Pry upwards on the retaining clip with black plastic spudger and pull to remove the 5 pin connector.

Step 7

  • Remove the two 10mm Philips #2 screws holding the brown printed circuit board to the vacuum.
  • Remove brown printed circuit board.
  • Pull up on clear plastic power button assembly to remove.

Remove the two 10mm Philips #2 screws holding the brown printed circuit board to the vacuum.

Remove brown printed circuit board.

Pull up on clear plastic power button assembly to remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Thibaut Pillot

Member since: 02/15/2018

434 Reputation

                                      5 Guides authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team S16-G3, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S16-G3, Boczar Spring 2018 



                    USFT-BOCZAR-S18S16G3                     


                                            4 Members                     


                                            12 Guides authored