Difficulty
Easy
Steps
11
Time Required
15 minutes
Sections
2
- Battery
- 5 steps
- Speaker
- 6 steps
Flags
0
BackInsignia NS-SPBTBRICK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Run your hand around the device where the sleeve connects, lifting lightly up until the edges detach from the device case.
Run your hand around the device where the sleeve connects, lifting lightly up until the edges detach from the device case.
1024
Step 2
- Turn the device around and gently push the speaker through until it separates from the sleeve.
Turn the device around and gently push the speaker through until it separates from the sleeve.
Step 3
- Using a Phillips #0 screwdriver, remove the the ten 5.1mm screws that hold down the battery panel on the bottom of the speaker unit.
Using a Phillips #0 screwdriver, remove the the ten 5.1mm screws that hold down the battery panel on the bottom of the speaker unit.
Step 4
- Using your hands, pry the panel off of the top of the device to reveal the device circuit board and the battery attached to the inner side of the panel.
Using your hands, pry the panel off of the top of the device to reveal the device circuit board and the battery attached to the inner side of the panel.
Step 5
- Using tweezers, carefully detach the battery wire from the circuit board and lift out the panel with the attached battery.
Using tweezers, carefully detach the battery wire from the circuit board and lift out the panel with the attached battery.
Step 6
Speaker
- Using hands or a spudger, pry the front side of the plastic shielding (side opposite of power, control, and auxiliary port cover) from the device.
Using hands or a spudger, pry the front side of the plastic shielding (side opposite of power, control, and auxiliary port cover) from the device.
Step 7
- Lift the front plastic shielding from the device.
Lift the front plastic shielding from the device.
Step 8
- Using a Phillips #1 screwdriver, remove the eight 10mm screws on the revealed front panel.
Using a Phillips #1 screwdriver, remove the eight 10mm screws on the revealed front panel.
Step 9
- Turn the device around and remove the rear panel from the device to reveal the device’s speaker units.
Turn the device around and remove the rear panel from the device to reveal the device’s speaker units.
Step 10
- Remove the speaker brackets of the speaker to be replaced by unscrewing the three 7.5mm screws holding them in place with the Phillips #1 screwdriver.
- If the brackets do not come out with the screws you may need to pull them out with tweezers.
Remove the speaker brackets of the speaker to be replaced by unscrewing the three 7.5mm screws holding them in place with the Phillips #1 screwdriver.
If the brackets do not come out with the screws you may need to pull them out with tweezers.
Step 11
- Using tweezers, detach the cord connecting the speaker to the device and lift out the speaker.
Using tweezers, detach the cord connecting the speaker to the device and lift out the speaker.
If desired, repeat steps 10 and 11 to replace the other speaker within the device. Follow the steps of this guide and the battery replacement guide in reverse order to reassemble the device.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
ETHAN BRUNHOFER
Member since: 03/26/2018
152 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
IUPUI, Team S2-G6, Harley Spring 2018
Member of IUPUI, Team S2-G6, Harley Spring 2018
IUPUI-HARLEY-S18S2G6
3 Members
2 Guides authored
