Difficulty

Moderate

Steps

6

Time Required

                          10 minutes

Sections

2

  • Insignia NS-PLTPSP13 Disassembly
  • 5 steps
  • Speaker Cone
  • 1 step

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackInsignia NS-PLTPSP13

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Insignia NS-PLTPSP13 Disassembly
  • Use the tweezers to lift the corner of the mesh until a gap is created.

Use the tweezers to lift the corner of the mesh until a gap is created.

1024

Step 2

  • Once there is a gap big enough, insert the metal spudger, and remove the tweezers.

Once there is a gap big enough, insert the metal spudger, and remove the tweezers.

Step 3

  • Now take the size J0 JIS screwdriver to remove the seven 5 mm screws on the plastic casing of the speaker.
  • Do not forget about the 5mm screw on the backside of the speaker, it may be covered by a white sticker, and it will prevent you from removing the plastic cover.

Now take the size J0 JIS screwdriver to remove the seven 5 mm screws on the plastic casing of the speaker.

Do not forget about the 5mm screw on the backside of the speaker, it may be covered by a white sticker, and it will prevent you from removing the plastic cover.

Step 4

  • Once all seven 5mm screws are taken off use the metal spudger again to pry off the plastic casing from the speaker.

Once all seven 5mm screws are taken off use the metal spudger again to pry off the plastic casing from the speaker.

Step 5

  • To further take apart the speaker, there are also two 5mm screws on the green circuit board which keep the speaker and circuit board attached. Unscrew these with the size J0 JIS screwdriver.

To further take apart the speaker, there are also two 5mm screws on the green circuit board which keep the speaker and circuit board attached. Unscrew these with the size J0 JIS screwdriver.

Step 6

              Speaker Cone
  • Follow How To Solder and Desolder Connections to desolder the speaker cone from the circuit board.

Follow How To Solder and Desolder Connections to desolder the speaker cone from the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Colin Farragher

Member since: 03/21/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       UMass Dartmouth, Team S4-G2, Julie Spring 2017                        

                                                  Member of UMass Dartmouth, Team S4-G2, Julie Spring 2017 



                    UMASSD-JULIE-S17S4G2                     


                                            5 Members                     


                                            4 Guides authored