Difficulty

Moderate

Steps

5

Time Required

                          15 minutes

Sections

2

  • Front Case
  • 2 steps
  • Power Cord
  • 3 steps

Flags

0

  • BackInsignia NS-HTMC01-B

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Case
  • Flip the device over so the back panel faces up.
  • Unscrew the four screws counter-clockwise from the back panel using a 4mm Phillips screwdriver.
  • You may want to use a flashlight during this step, as the screws are hard to see.
  • Make sure to firmly connect your screwdriver with the head of the screw. A loose connection can strip the screw head, making the screws nearly impossible to remove.

Flip the device over so the back panel faces up.

Unscrew the four screws counter-clockwise from the back panel using a 4mm Phillips screwdriver.

You may want to use a flashlight during this step, as the screws are hard to see.

Make sure to firmly connect your screwdriver with the head of the screw. A loose connection can strip the screw head, making the screws nearly impossible to remove.

1024

Step 2

  • Take the screws out and set them aside.
  • Be sure to set them somewhere flat, so they don’t roll away.
  • Gently pull the front panel and back panel apart to open the device.

Take the screws out and set them aside.

Be sure to set them somewhere flat, so they don’t roll away.

Gently pull the front panel and back panel apart to open the device.

Step 3

              Power Cord
  • Use a Phillips #2 screwdriver to remove the two 1.7mm screws from the white triangular piece covering the power cord.

Use a Phillips #2 screwdriver to remove the two 1.7mm screws from the white triangular piece covering the power cord.

Step 4

  • Disconnect all of the blue wires. There should be 3 separate blue-wire connections.

Disconnect all of the blue wires. There should be 3 separate blue-wire connections.

Step 5

  • Disconnect the second black wire from the rectangular piece above the Tip-Over Safety Switch.
  • Remove power cord.

Disconnect the second black wire from the rectangular piece above the Tip-Over Safety Switch.

Remove power cord.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Rebecca Nunez

Member since: 01/31/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       University of North Texas, Team 1-1, Campbell Spring 2017                        

                                                  Member of University of North Texas, Team 1-1, Campbell Spring 2017 



                    UNT-CAMPBELL-S17S1G1                     


                                            3 Members                     


                                            6 Guides authored