Difficulty

Easy

Steps

4

Time Required

                          15 - 20 minutes            

Sections

1

  • Power Button
  • 4 steps

Flags

0

  • BackInsignia NS-HTMC01-B

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Button               
  • Flip your device over so the bottom panel faces you. You should see a hole containing a screw in each corner of the device.
  • Insert a 4-inch Phillips #1 screwdriver into each hole until connected with the 20 millimeter, sharp-point screw.

Flip your device over so the bottom panel faces you. You should see a hole containing a screw in each corner of the device.

Insert a 4-inch Phillips #1 screwdriver into each hole until connected with the 20 millimeter, sharp-point screw.

1024

Step 2

  • Find the power switch, located inside the heater on the bottom left corner.

Find the power switch, located inside the heater on the bottom left corner.

Step 3

  • Using a Phillips #1 screwdriver, unscrew the two 7 millimeter screws attaching the power switch to the power button.

Using a Phillips #1 screwdriver, unscrew the two 7 millimeter screws attaching the power switch to the power button.

Step 4

  • Find the clips holding the power button in place.
  • Press down on the clips to remove the button.

Find the clips holding the power button in place.

Press down on the clips to remove the button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Jack Casey                     

Member since: 01/31/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       University of North Texas, Team 1-1, Campbell Spring 2017                        

                                                  Member of University of North Texas, Team 1-1, Campbell Spring 2017 



                    UNT-CAMPBELL-S17S1G1                     


                                            3 Members                     


                                            6 Guides authored