Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

1

  • Buttons
  • 5 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackInsignia NS-CSPBTHOL-R

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Buttons
  • Use the spudger to pry off the plastic grate covering the speakers, then gently pull it off with your fingers.

Use the spudger to pry off the plastic grate covering the speakers, then gently pull it off with your fingers.

1024

Step 2

  • once the grate has been removed, Remove the six 3mm screws using the J00 JIS screw bit. This will require a long, narrow screwdriver.

once the grate has been removed, Remove the six 3mm screws using the J00 JIS screw bit. This will require a long, narrow screwdriver.

Step 3

  • Insert the Spudger between the corners of base and the face of the speaker to open the device. The screw on the upper right corner may be difficult to take out. If you cannot take it out with a screwdriver, using force to pull the face of the speaker apart may break the plastic that surrounds the screw.

Insert the Spudger between the corners of base and the face of the speaker to open the device. The screw on the upper right corner may be difficult to take out. If you cannot take it out with a screwdriver, using force to pull the face of the speaker apart may break the plastic that surrounds the screw.

Step 4

  • Gently pull apart the speaker to separate the speakers from the battery and motherboard. Then pull out the motherboard with your fingers by grabbing the edges and pulling upwards.

Gently pull apart the speaker to separate the speakers from the battery and motherboard. Then pull out the motherboard with your fingers by grabbing the edges and pulling upwards.

Step 5

  • Desolder the four contact points from the button that is unresponsive.
  • Check out this helpful guide for soldering and desoldering tips.

Desolder the four contact points from the button that is unresponsive.

Check out this helpful guide for soldering and desoldering tips.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Zachary Foltz

Member since: 02/15/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       USF Tampa, Team 12-6, Eyestone Spring 2017                        

                                                  Member of USF Tampa, Team 12-6, Eyestone Spring 2017 



                    USFT-EYESTONE-S17S12G6                     


                                            3 Members                     


                                            4 Guides authored