Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

4

  • Battery
  • 2 steps
  • External Antenna
  • 1 step
  • Casing
  • 2 steps
  • Antenna Base
  • 1 step

Flags

0

  • BackInsignia NS-B4111

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Unplug and remove the power cord. Turn the boombox upside down.
  • Grip the sides of the case and use your thumbs to pop open the battery cover.

Unplug and remove the power cord. Turn the boombox upside down.

Grip the sides of the case and use your thumbs to pop open the battery cover.

1024

Step 2

  • Pry out the batteries with your fingers.

Pry out the batteries with your fingers.

Step 3

              External Antenna
  • Set the boombox upright. Remove the 4mm screw and the two 6mm washers with the Phillips PH1 screwdriver.
  • Remove the external antenna.

Set the boombox upright. Remove the 4mm screw and the two 6mm washers with the Phillips PH1 screwdriver.

Remove the external antenna.

Step 4

              Casing
  • Turn the boombox upside down again. With the Phillips PH1 or the Flathead #3 screwdriver, remove the three 14mm black screws.
  • Remove the four 18mm chrome screws with the Phillips PH1 screwdriver.

Turn the boombox upside down again. With the Phillips PH1 or the Flathead #3 screwdriver, remove the three 14mm black screws.

Remove the four 18mm chrome screws with the Phillips PH1 screwdriver.

Step 5

  • Gently remove the bottom half of the casing from the top half of the casing.
  • The antenna base is connected to the motherboard by a red wire. This wire will prevent the two halves from separating completely.

Gently remove the bottom half of the casing from the top half of the casing.

The antenna base is connected to the motherboard by a red wire. This wire will prevent the two halves from separating completely.

Step 6

              Antenna Base
  • Remove the 10mm chrome screw from the antenna base with the Phillips PH1 screwdriver. Remove the antenna base from the casing.
  • This red wire will now be loose and you can move it out of the antenna base slot.

Remove the 10mm chrome screw from the antenna base with the Phillips PH1 screwdriver. Remove the antenna base from the casing.

This red wire will now be loose and you can move it out of the antenna base slot.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Kristin Yoshioka

Member since: 09/21/2016

984 Reputation

                                      9 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       UC Davis, Team 1-5, Oliver Fall 2016                        

                                                  Member of UC Davis, Team 1-5, Oliver Fall 2016 



                    UCD-OLIVER-F16S1G5                     


                                            5 Members                     


                                            11 Guides authored