Insignia Ns 15Ms0832B Battery Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          15 - 20 minutes

Sections

Battery
8 steps

Flags

BackInsignia NS-15MS0832B
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Begin the replacement for the battery by opening up the device with a plastic opening tool along the edge.
Work the plastic opening tool along the edge until you have separated the screen from the back plate.

Begin the replacement for the battery by opening up the device with a plastic opening tool along the edge.

Work the plastic opening tool along the edge until you have separated the screen from the back plate.

1024

Step 2

Your tablet should look like this once separated.

Your tablet should look like this once separated.

Step 3

Start by placing tablet face down and carefully removing the mesh wire tap from the back of the battery.

Start by placing tablet face down and carefully removing the mesh wire tap from the back of the battery.

Step 4

Remove the flat wire from its connector with the tweezers and fold to the side so that it’s clear of the battery.

Remove the flat wire from its connector with the tweezers and fold to the side so that it’s clear of the battery.

Step 5

Next locate where the battery has three wires attached to the mother board. Take out the soldering iron and begin heating it up.
Check out iFixit’s How to Solder and Desolder Connections guide for soldering help.

Next locate where the battery has three wires attached to the mother board. Take out the soldering iron and begin heating it up.

Check out iFixit’s How to Solder and Desolder Connections guide for soldering help.

Step 6

Once the soldering iron has heated up, begin by placing the tip of the iron where the wire directly meets the mother board. The soldering should heat up and allow you to gently pull the wire off. Repeat twice more to remove each of the three wires.

Once the soldering iron has heated up, begin by placing the tip of the iron where the wire directly meets the mother board. The soldering should heat up and allow you to gently pull the wire off. Repeat twice more to remove each of the three wires.

Step 7

Once all wires have been removed from mother board, take plastic opening tool and separate the battery from the back of the screen. Its connected with glue, so don’t worry.

Once all wires have been removed from mother board, take plastic opening tool and separate the battery from the back of the screen. Its connected with glue, so don’t worry.

Step 8

Remove battery and replace faulty one with new battery.

Remove battery and replace faulty one with new battery.

To reassemble your Insignia W-Fi Windows 8" Tablet, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Harrison Smith

Member since: 10/19/2016

329 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Texas Tech, Team 1-1, Bennett Fall 2016                        

                                                  Member of Texas Tech, Team 1-1, Bennett Fall 2016 



                    TTU-BENNETT-F16S1G1                     


                                            4 Members                     


                                            6 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team