Difficulty
Moderate
Steps
6
Time Required
30 minutes
Sections
1
- Water Tray
- 6 steps
Flags
0
BackInsignia Ice Maker NS-IMP26SS7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Water Tray
- Remove the 6 screws holding the rear casing on.
- Remove the rear casing
Remove the 6 screws holding the rear casing on.
Remove the rear casing
1024
Step 2
- Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.
Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.
Step 3
- Remove the 4 screws holding the Ice Tray from the top.
Remove the 4 screws holding the Ice Tray from the top.
Step 4
- Lift the Water Pump out of the way
Lift the Water Pump out of the way
Step 5
- Remove the final 2 screws.
Remove the final 2 screws.
Step 6
- Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.
- Disconnect the water tray cord.
Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.
Disconnect the water tray cord.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Evan Taylor
Member since: 01/18/2018
592 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team S21-G3, Banghart Winter 2018
Member of Cal Poly, Team S21-G3, Banghart Winter 2018
CPSU-BANGHART-W18S21G3
2 Members
5 Guides authored
razorbllade - Jun 5, 2019
Reply
Where do I find insignia ice maker ns- imp26ss7 replacement ice forming tray? Can’t locate item on the internet.
er.vanlaarhoven - Dec 12, 2022
I found a seller on ebay that has 7 of them and is selling them for $20 shipped
