Difficulty
Moderate
Steps
9
Time Required
15 minutes
Sections
2
- Back Casing
- 2 steps
- Cameras
- 7 steps
Flags
0
BackInsignia Flex 8 NS-P16AT08
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Casing
- Make sure device is powered off.
- Wedge the plastic opening tool anywhere in the seam between the back casing and screen.
- Slide the plastic opening tool along the sides and corners of the seam of the device while it separates from the screen.
- You will hear the popping sound of the plastic connections separating from the device.
Make sure device is powered off.
Wedge the plastic opening tool anywhere in the seam between the back casing and screen.
Slide the plastic opening tool along the sides and corners of the seam of the device while it separates from the screen.
You will hear the popping sound of the plastic connections separating from the device.
1024
Step 2
- Lift the back casing away from the screen.
- Set casing aside.
Lift the back casing away from the screen.
Set casing aside.
Step 3
Cameras
- Gently peel all of the tape that is covering the cable connections going to and from the cameras. Set the tape aside for later reassembly.
Gently peel all of the tape that is covering the cable connections going to and from the cameras. Set the tape aside for later reassembly.
Step 4
- Locate camera ribbon connector.
- Using finger flip up black flap of camera ribbon connector.
Locate camera ribbon connector.
Using finger flip up black flap of camera ribbon connector.
Step 5
- Gently pull camera connector ribbon by hand until it separates from connector.
Gently pull camera connector ribbon by hand until it separates from connector.
Step 6
- Using metal spudger tool, gently pry right speaker away from adhesive.
- Always use a nylon spudger or plastic opening tool before a metal spudger. Metal spudgers are great for serious prying power but can damage your device if used incorrectly.
- Move right speaker to left side of device so you can freely access the camera ribbon.
Using metal spudger tool, gently pry right speaker away from adhesive.
Always use a nylon spudger or plastic opening tool before a metal spudger. Metal spudgers are great for serious prying power but can damage your device if used incorrectly.
Move right speaker to left side of device so you can freely access the camera ribbon.
Step 7
- Using metal spudger tool, gently pry the rear-facing camera from the adhesive.
Using metal spudger tool, gently pry the rear-facing camera from the adhesive.
Step 8
- Lift up connector ribbon that is attached to the cameras.
- Slide cameras and connector ribbon out from underneath the speaker cords and battery.
Lift up connector ribbon that is attached to the cameras.
Slide cameras and connector ribbon out from underneath the speaker cords and battery.
Step 9
- Remove connector ribbon and cameras from device casing.
Remove connector ribbon and cameras from device casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Emily Guidinger
Member since: 04/01/2016
527 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
Eastern Washington University, Team 2-1, Andersen Spring 2016
Member of Eastern Washington University, Team 2-1, Andersen Spring 2016
EWU-ANDERSEN-S16S2G1
5 Members
10 Guides authored
