Difficulty
Moderate
Steps
5
Time Required
15 minutes
Sections
1
- Battery
- 5 steps
Flags
0
BackInsignia Flex 8 NS-14T002
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Make sure the power is off to avoid injury in the following steps.
- Position the tablet so that the screen is face down.
- The power button is located in the upper left hand corner.
- Hold the power button for three seconds until the tablet powers down.
Make sure the power is off to avoid injury in the following steps.
Position the tablet so that the screen is face down.
The power button is located in the upper left hand corner.
Hold the power button for three seconds until the tablet powers down.
1024
Step 2
- Remove the back casing by sliding a credit card or a similarly thin but firm object in between the casing and the screen.
- Run this object around the perimeter of the tablet until there is separation between the casing and the screen.
- Remove the back casing and set aside.
Remove the back casing by sliding a credit card or a similarly thin but firm object in between the casing and the screen.
Run this object around the perimeter of the tablet until there is separation between the casing and the screen.
Remove the back casing and set aside.
Step 3
- Peel back the tape from battery and case.
Peel back the tape from battery and case.
Step 4
- Slide the spudger beneath battery to pry away it away from the case. Work around the battery, prying up all edges to remove from glue.
- Do not puncture or bend battery. This could cause battery to leak acid.
Slide the spudger beneath battery to pry away it away from the case. Work around the battery, prying up all edges to remove from glue.
Do not puncture or bend battery. This could cause battery to leak acid.
Step 5
- Desolder the black, yellow and red connections from circuit board. Desoldering Help
- Keep the soldering tool away from other components on the circuit board.
Desolder the black, yellow and red connections from circuit board. Desoldering Help
Keep the soldering tool away from other components on the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 2 other contributors
Tyler Tyrrell
Member since: 03/11/2015
890 Reputation
4 Guides authored
Badges:
17
+14 more badges
Team
Colorado Springs, Team 5-5, Panko Spring 2015
Member of Colorado Springs, Team 5-5, Panko Spring 2015
UCCS-PANKO-S15S5G5
3 Members
12 Guides authored
