Difficulty

Moderate

Steps

6

Time Required

                          10 - 20 minutes

Sections

2

  • Power Removal
  • 4 steps
  • Speakers
  • 2 steps

Flags

1

Missing Prerequisites

This guide is missing information on how to start the process. Make a prerequisite guide!

  • BackInsignia Flex 11.6

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Removal
  • Before working on the device, make sure the device is off and not plugged into any power source for safety reasons. Failure to comply could result in injury.
  • Place the device on a firm surface with the device screen facing down.

Before working on the device, make sure the device is off and not plugged into any power source for safety reasons. Failure to comply could result in injury.

Place the device on a firm surface with the device screen facing down.

1024

Step 2

  • Remove 2, 6.1 mm Phillips J000 screws from the back of the device.
  • If any screws are stripped, refer to the ifixit guide for how to remove a stripped screw. How to Remove a Stripped Screw

Remove 2, 6.1 mm Phillips J000 screws from the back of the device.

If any screws are stripped, refer to the ifixit guide for how to remove a stripped screw. How to Remove a Stripped Screw

Step 3

  • Using a plastic tool and the plastic card, gently pry off the back cover.

Using a plastic tool and the plastic card, gently pry off the back cover.

Step 4

  • Using tweezers, remove the electrical connector that connects to the battery to remove the power to the battery.

Using tweezers, remove the electrical connector that connects to the battery to remove the power to the battery.

Step 5

              Speakers
  • Remove 2 electrical connectors that connects to the speaker using flat tweezers.

Remove 2 electrical connectors that connects to the speaker using flat tweezers.

Step 6

  • Remove 2 - 6 mm J000 Phillips screws from each of the speakers.
  • Speakers will pop out at this point.

Remove 2 - 6 mm J000 Phillips screws from each of the speakers.

Speakers will pop out at this point.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Connor Sweeney

Member since: 09/28/2016

422 Reputation

                                      5 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       Eastern Washington University, Team 2-4, Mathisen Fall 2016                        

                                                  Member of Eastern Washington University, Team 2-4, Mathisen Fall 2016 



                    EWU-MATHISEN-F16S2G4                     


                                            4 Members                     


                                            10 Guides authored