Difficulty

Easy

Steps

5

Time Required

                          15 minutes

Sections

1

  • Camera
  • 5 steps

Flags

0

  • BackInsignia Flex 10.1 NS-P16AT10

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Camera
  • Make sure your device is off and not connected to any power sources to avoid injury
  • Use a plastic opening tool to remove the rear panel from the front case.
  • Insert the plastic opening tool between the front case and rear panel. Use a prying motion to lift the front case from the rear panel.
  • The volume rocker and power button will become free from the device when the front and rear panels are separated from each other. Do not worry. These pieces are easily put back into place when reassembling the tablet.

Make sure your device is off and not connected to any power sources to avoid injury

Use a plastic opening tool to remove the rear panel from the front case.

Insert the plastic opening tool between the front case and rear panel. Use a prying motion to lift the front case from the rear panel.

The volume rocker and power button will become free from the device when the front and rear panels are separated from each other. Do not worry. These pieces are easily put back into place when reassembling the tablet.

1024

Step 2

  • Use a plastic opening tool to flip up the ribbon connector that connects the camera to the motherboard.
  • Free the ribbon cable from the motherboard.

Use a plastic opening tool to flip up the ribbon connector that connects the camera to the motherboard.

Free the ribbon cable from the motherboard.

Step 3

  • Use a #00 Phillips head screw driver to remove the two screws that hold the camera down to the front case.

Use a #00 Phillips head screw driver to remove the two screws that hold the camera down to the front case.

Step 4

  • Use tweezers or your fingers to remove the camera from your Insignia Flex 10.1 NS-P16AT10.

Use tweezers or your fingers to remove the camera from your Insignia Flex 10.1 NS-P16AT10.

Step 5

  • The camera is now free and ready to be replaced.

The camera is now free and ready to be replaced.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Morgan Kidd

Member since: 10/10/2016

416 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Texas Tech, Team 12-3, Bennett Fall 2016                        

                                                  Member of Texas Tech, Team 12-3, Bennett Fall 2016 



                    TTU-BENNETT-F16S12G3                     


                                            3 Members                     


                                            6 Guides authored