Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
1
- Camera
- 6 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackInsignia Flex 10.1 NS-P10W8100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Camera
- Carefully open the laptop and remove the keyboard by disconnecting it.
- Place keyboard to the side as you will not need it.
- Beware of plastic clips on the side of the device.
Carefully open the laptop and remove the keyboard by disconnecting it.
Place keyboard to the side as you will not need it.
Beware of plastic clips on the side of the device.
1024
Step 2
- Lay the screen flat on its surface and use the iFixit opening tool to remove the cover by gently prying the back cover from the screen.
- Apply the opening tool to each side to help pry the back cover evenly.
- Apply the opening tool to each side which will help pry the back cover evenly.
- Do not pry on the bottom side of the device. This is the side across from the camera.
Lay the screen flat on its surface and use the iFixit opening tool to remove the cover by gently prying the back cover from the screen.
Apply the opening tool to each side to help pry the back cover evenly.
Apply the opening tool to each side which will help pry the back cover evenly.
Do not pry on the bottom side of the device. This is the side across from the camera.
Step 3
- Use your fingers and pry the back cover from the screen. You may need to wiggle the cover a bit to separate the pieces.
- If the back cover does not come off work your fingers around the corners and slowly pry the cover off using your fingers.
- Be careful with potential sharp edges and any exposed electrical components.
Use your fingers and pry the back cover from the screen. You may need to wiggle the cover a bit to separate the pieces.
If the back cover does not come off work your fingers around the corners and slowly pry the cover off using your fingers.
Be careful with potential sharp edges and any exposed electrical components.
Step 4
- Carefully remove the yellow tape holding down the camera ribbon connector by pulling it upwards.
- Remove the black tape holding down the camera ribbon connector which is attached to the motherboard.
Carefully remove the yellow tape holding down the camera ribbon connector by pulling it upwards.
Remove the black tape holding down the camera ribbon connector which is attached to the motherboard.
Step 5
- Disconnect the zero insertion force (ZIF) connector by using your fingernail to flip the small locking flap.
- Disconnect the cable by gently pulling it outward.
Disconnect the zero insertion force (ZIF) connector by using your fingernail to flip the small locking flap.
Disconnect the cable by gently pulling it outward.
Step 6
- Remove the camera by pulling it upward.
Remove the camera by pulling it upward.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Edgar Rodriguez
Member since: 02/12/2019
971 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
Western Carolina University, Team S1-G2, Virtue Spring 2019
Member of Western Carolina University, Team S1-G2, Virtue Spring 2019
WCU-VIRTUE-S19S1G2
4 Members
5 Guides authored
