Difficulty
Difficult
Steps
6
Time Required
10 - 15 minutes
Sections
2
- Back Case
- 3 steps
- Speakers
- 3 steps
Flags
0
BackInsignia Flex 10.1 NS-P10A6100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Case
- Make sure your tablet is turned off and not connected to a power source to prevent personal injury.
- The volume rocker and power button located on the top edge by the camera are not connected pieces and will become free from the device once the front panel is removed from the back case. They are easily put back in place when reassembling the tablet.
- Position the tablet with the top edge by the camera facing down.
- Insert the plastic opening tool between the front panel and back case at the upper left hand corner of the tablet.
Make sure your tablet is turned off and not connected to a power source to prevent personal injury.
The volume rocker and power button located on the top edge by the camera are not connected pieces and will become free from the device once the front panel is removed from the back case. They are easily put back in place when reassembling the tablet.
Position the tablet with the top edge by the camera facing down.
Insert the plastic opening tool between the front panel and back case at the upper left hand corner of the tablet.
1024
Step 2
- Slide the plastic opening tool along the edge of the tablet between the front panel and back case.
- Repeat this process for the two shorter edges of the tablet leaving the top edge by the camera still snapped in place.
Slide the plastic opening tool along the edge of the tablet between the front panel and back case.
Repeat this process for the two shorter edges of the tablet leaving the top edge by the camera still snapped in place.
Step 3
- Using an unfolding motion along the top edge of the tablet, carefully separate the front panel from the back case.
Using an unfolding motion along the top edge of the tablet, carefully separate the front panel from the back case.
Step 4
Speakers
- Using the Phillips #000 screw driver, unscrew the four 4 mm screws securing the speakers to the front panel in a counterclockwise direction.
- The four screws are very small, so be careful not to lose them after unscrewing them.
Using the Phillips #000 screw driver, unscrew the four 4 mm screws securing the speakers to the front panel in a counterclockwise direction.
The four screws are very small, so be careful not to lose them after unscrewing them.
Step 5
- Unhook the woven red and black wires from the plastic hooks that hold them in place against the front panel
Unhook the woven red and black wires from the plastic hooks that hold them in place against the front panel
Step 6
- Desoldering can cause fumes that are dangerous to breathe in, and materials may be hot.
- Desolder the four joints connecting the red and black wires from the speakers to the motherboard.
- A thorough guide including step by step instructions on how to solder and desolder can be found here.
Desoldering can cause fumes that are dangerous to breathe in, and materials may be hot.
Desolder the four joints connecting the red and black wires from the speakers to the motherboard.
A thorough guide including step by step instructions on how to solder and desolder can be found here.
The speakers are now free from the device and can be replaced. To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Samantha Damewood
Member since: 10/29/2016
961 Reputation
5 Guides authored
Badges:
15
+12 more badges
Team
Baylor, Team 5-8, Williams Fall 2016
Member of Baylor, Team 5-8, Williams Fall 2016
BU-WILLIAMS-F16S5G8
3 Members
12 Guides authored
