Infinity V2 10 1 Speakers Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Back Case
2 steps
Speakers
1 step

Flags

BackInfinity v2 10.1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Warning: When using this guide, follow all the safety warnings and instructions related to soldering to avoid injury.

What you need

Step 1

              Back Case

Slightly pry open one corner of the device by using your finger nail to separate the screen from the back case.
Use an opening tool to carefully detach the back case from the tablet. Start by inserting the tool where your fingernail opened a gap, and work around all four sides of the device.
There will be a slight click noise as you free each tab.
Once the case is completely free, carefully lift it and place it face up on the workstation, being cautious not to damage the speaker wires connecting the two halves.

Slightly pry open one corner of the device by using your finger nail to separate the screen from the back case.

Use an opening tool to carefully detach the back case from the tablet. Start by inserting the tool where your fingernail opened a gap, and work around all four sides of the device.

There will be a slight click noise as you free each tab.

Once the case is completely free, carefully lift it and place it face up on the workstation, being cautious not to damage the speaker wires connecting the two halves.

1024

Step 2

Remove the speakers from the case by gently lifting them up and out of their slots.

Remove the speakers from the case by gently lifting them up and out of their slots.

Step 3

              Speakers

Turn on your soldering iron and allow it to heat up. Once it is hot, press the tip of the iron to the both of the solder points that attach the wires to the motherboard until the solder is melted.
Once the solder is melted, use tweezers to remove the wires from the motherboard.
The solder and iron will be extremely hot. You can use tweezers to grab the wire to avoid burning your fingers from accidental contact with the iron.

Turn on your soldering iron and allow it to heat up. Once it is hot, press the tip of the iron to the both of the solder points that attach the wires to the motherboard until the solder is melted.

Once the solder is melted, use tweezers to remove the wires from the motherboard.

The solder and iron will be extremely hot. You can use tweezers to grab the wire to avoid burning your fingers from accidental contact with the iron.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Nate Rice

Member since: 10/31/2019

321 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UMass Dartmouth, Team S2-G4, Barthe Fall 2019                        

                                                  Member of UMass Dartmouth, Team S2-G4, Barthe Fall 2019 



                    UMASSD-BARTHE-F19S2G4                     


                                            3 Members                     


                                            6 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team