Featured
Featured Guide
Difficulty
Easy
Steps
3
Time Required
5 - 10 minutes
Sections
2
- Access Door
- 1 step
- RAM
- 2 steps
Flags
1
Featured Guide
This guide has been found to be exceptionally cool by the iFixit staff.
BackiMac Intel 21.5" EMC 2308
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Access Door
- Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.
- These screws will remain captive in the access door.
- Remove the access door from your iMac.
- During reassembly, fasten the access door loosely and align it with the pocket cut into the outer case of the iMac before fully tightening the screws.
Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.
These screws will remain captive in the access door.
Remove the access door from your iMac.
During reassembly, fasten the access door loosely and align it with the pocket cut into the outer case of the iMac before fully tightening the screws.
1024
Step 2
RAM
- Use the sharp tip of a spudger to pull the black plastic RAM tabs out of the memory bay.
Use the sharp tip of a spudger to pull the black plastic RAM tabs out of the memory bay.
Step 3
- Pull the black plastic RAM tab away from your iMac to eject the RAM chip.
- Grab the RAM chip by its edges and pull it straight out of its slot.
- If two RAM chips are installed, repeat this process for the other chip.
Pull the black plastic RAM tab away from your iMac to eject the RAM chip.
Grab the RAM chip by its edges and pull it straight out of its slot.
If two RAM chips are installed, repeat this process for the other chip.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
109 other people completed this guide.
Author
with 5 other contributors
Andrew Bookholt
575,478 Reputation
618 Guides authored
Badges:
47
+44 more badges
Mary - Dec 30, 2020
Reply
There needs to be a little bit of important discucssion about getting the new RAM properly seated into the slots. Otherwise, great instructions!