Difficulty
Easy
Steps
4
Time Required
Suggest a time??
Sections
2
- Rear Panel
- 2 steps
- Fan Duct
- 2 steps
Flags
0
BackiMac G5 20" Model A1076
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Panel
- Lay the iMac display-side down on a flat surface.
- Loosen the three Phillips screws securing the rear panel to the iMac.
- These screws are captive in the iMac. The center screw will stop turning after about 3.5 turns and the outer screws will stop turning after about 5.5 turns. Do not try to remove these screws from your iMac.
Lay the iMac display-side down on a flat surface.
Loosen the three Phillips screws securing the rear panel to the iMac.
These screws are captive in the iMac. The center screw will stop turning after about 3.5 turns and the outer screws will stop turning after about 5.5 turns. Do not try to remove these screws from your iMac.
1024
Step 2
- Lift the rear panel slightly near the bottom of the iMac.
- Pull the rear panel toward yourself and remove it from the iMac.
Lift the rear panel slightly near the bottom of the iMac.
Pull the rear panel toward yourself and remove it from the iMac.
Step 3
Fan Duct
- Remove the following two screws:
- One 11 mm T10 Torx.
- One 10.6 mm T8 Torx.
Remove the following two screws:
One 11 mm T10 Torx.
One 10.6 mm T8 Torx.
Step 4
- Lift the fan duct out of the chassis.
Lift the fan duct out of the chassis.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 3 other contributors
Andrew Bookholt
575,478 Reputation
618 Guides authored
Badges:
47
+44 more badges