Difficulty

Moderate

Steps

9

Time Required

                          30 minutes

Sections

3

  • Bottom Plate
  • 3 steps
  • Bottom Plate Housing
  • 2 steps
  • Drive Carrier Assembly
  • 4 steps

Flags

0

  • BackiMac G4 17 800 MHz EMC 1936

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Bottom Plate
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

1024

Step 2

  • Loosen the four Phillips #0 screws.

Loosen the four Phillips #0 screws.

Step 3

  • Carefully remove the base access panel.

Carefully remove the base access panel.

Step 4

              Bottom Plate Housing
  • Remove the four 25mm T-15 screws.

Remove the four 25mm T-15 screws.

Step 5

  • Open the housing plate.
  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.
  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

Open the housing plate.

Be gentle with the wires still connected to the logic board so as not to ruin the cables.

A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

Step 6

              Drive Carrier Assembly
  • Remove the 2 torx 10mm screws on the EMI shield
  • Carefully remove shield and copper tape

Remove the 2 torx 10mm screws on the EMI shield

Carefully remove shield and copper tape

Step 7

  • Remove the 4 10mm torx screws attatched to the drive carrier.
  • The drive carrier includes optical drive and hard drive.

Remove the 4 10mm torx screws attatched to the drive carrier.

The drive carrier includes optical drive and hard drive.

Step 8

  • Grasp the carrier with both hands on each side.
  • Remove the carrier by lifting up and out.
  • Pull gently but firmly. The carrier is meant to fit snugly.

Grasp the carrier with both hands on each side.

Remove the carrier by lifting up and out.

Pull gently but firmly. The carrier is meant to fit snugly.

Step 9

  • Flip the removed carrier to the right and pull out power cables.

Flip the removed carrier to the right and pull out power cables.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 5 other contributors 


                    Courtney

Member since: 10/06/2011

1,068 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 21-22, Maness Fall 2011                        

                                                  Member of Cal Poly, Team 21-22, Maness Fall 2011 



                    CPSU-MANESS-F11S21G22                     


                                            4 Members                     


                                            13 Guides authored

David Hunter - Nov 17, 2011

Reply

What two screws in step 6

We need a “action” shot; we need to show an actual screwdriver unscrewing the screw.