Difficulty

Moderate

Steps

8

Time Required

                          30 - 45 minutes

Sections

1

  • Dials
  • 8 steps

Flags

0

  • BackiHome iH5

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Dials
  • Remove the eight screws from the bottom side of the iHome.

Remove the eight screws from the bottom side of the iHome.

1024

Step 2

  • Remove the cover to expose the inside.
  • With pliers, or tweezers,if needed, remove the three wire harnesses by gently pulling straight up on them.

Remove the cover to expose the inside.

With pliers, or tweezers,if needed, remove the three wire harnesses by gently pulling straight up on them.

Step 3

  • Remove the 5 screws with a #2 Phillips screwdriver.

Remove the 5 screws with a #2 Phillips screwdriver.

Step 4

  • Remove all wire harnesses from the bottom of the board. There eight wire harnesses.
  • There are capacitors all over the back side of the board. Be careful not to touch these capacitors (blue cylinders) as they can discharge—giving you a shock.

Remove all wire harnesses from the bottom of the board. There eight wire harnesses.

There are capacitors all over the back side of the board. Be careful not to touch these capacitors (blue cylinders) as they can discharge—giving you a shock.

Step 5

  • Remove the two screws from the speakers with a #2 Phillips screwdriver.
  • Turn the device on its front side and remove the two screws with a #2 Phillips screwdriver.
  • Pull the speaker up from the back as shown with the speaker on the right. Then pull the speaker straight back as shown with the speaker on the left.

Remove the two screws from the speakers with a #2 Phillips screwdriver.

Turn the device on its front side and remove the two screws with a #2 Phillips screwdriver.

Pull the speaker up from the back as shown with the speaker on the right. Then pull the speaker straight back as shown with the speaker on the left.

Step 6

  • Remove the front piece by pulling up until it hits the plastic pieces sticking out from the display screen. Then pull it out horizontally from the device.

Remove the front piece by pulling up until it hits the plastic pieces sticking out from the display screen. Then pull it out horizontally from the device.

Step 7

  • Remove the three screw from the dial with a #2 Phillips screwdriver.

Remove the three screw from the dial with a #2 Phillips screwdriver.

Step 8

  • Pull back the circuit board to access the plastic piece.
  • Lift to separate the plastic piece from the dial.
  • Replace the broken piece.

Pull back the circuit board to access the plastic piece.

Lift to separate the plastic piece from the dial.

Replace the broken piece.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 2 other contributors 


                    Maggie Hill

Member since: 03/20/2014

379 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       New Mexico State, Team 1-6, Easley Spring 2014                        

                                                  Member of New Mexico State, Team 1-6, Easley Spring 2014 



                    NMSU-EASLEY-S14S1G6                     


                                            5 Members                     


                                            4 Guides authored