Ihome Ibt230 Keyboard Buttons Replacement Repair Guide

Difficulty

Difficult

Steps

7

Time Required

                          15 - 20 minutes            

Sections

1

• Keyboard (Buttons)
• 7 steps

Flags

0

• BackiHome iBT230

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Keyboard (Buttons)               

• Remove the four 5.5 mm Phillips Head #00 screws from the bottom palate of the iBT230.

Remove the four 5.5 mm Phillips Head #00 screws from the bottom palate of the iBT230.

1024

Step 2

• Grip the top of the iBT230 by placing your thumb on the back portion, where the USB port is located. Pull up, and you should notice various different colored wires, connected to the Main Motherboard.

Grip the top of the iBT230 by placing your thumb on the back portion, where the USB port is located. Pull up, and you should notice various different colored wires, connected to the Main Motherboard.

Step 3

• Unplug the connectors from all sides of the iBT230, and unplug the wire connected to the screen.
• Make sure to note which wire goes where, you don’t want to re-solder the wires into the incorrect ports!

Unplug the connectors from all sides of the iBT230, and unplug the wire connected to the screen.

Make sure to note which wire goes where, you don’t want to re-solder the wires into the incorrect ports!

Step 4

• Unscrew the four 5.5 mm Phillips #00 face panel screws from the front screen.

Unscrew the four 5.5 mm Phillips #00 face panel screws from the front screen.

Step 5

• Once the four 5.5 mm Phillips #00 screws come out, slide the screen out vertically.
• Disconnect the blue tipped ribbon from the back of the screen.

Once the four 5.5 mm Phillips #00 screws come out, slide the screen out vertically.

Disconnect the blue tipped ribbon from the back of the screen.

Step 6

• Once the screen is removed, unscrew the six 4.0 mm Phillips #02 screws located on top of the keyboard.
• As shown in the image, the keyboard is represented by a brown colored palate.

Once the screen is removed, unscrew the six 4.0 mm Phillips #02 screws located on top of the keyboard.

As shown in the image, the keyboard is represented by a brown colored palate.

Step 7

• Disconnect the blue tipped ribbon from the back of the keyboard.

Disconnect the blue tipped ribbon from the back of the keyboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Bilal Siddiqui                     

Member since: 04/10/2017

376 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       UW Tacoma, Team S3-G6, Liner Spring 2017                        

                                                  Member of UW Tacoma, Team S3-G6, Liner Spring 2017 



                    UWT-LINER-S17S3G6                     


                                            4 Members                     


                                            3 Guides authored