Difficulty

Difficult

Steps

5

Time Required

                          15 - 20 minutes

Sections

2

  • Base Plate
  • 2 steps
  • Auxiliary Port
  • 3 steps

Flags

0

  • BackiHome iBT16

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Base Plate
  • Make sure to flip the device over to get into the correct orientation
  • Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.
  • Make sure to keep these screws in a safe location so you don’t lose them

Make sure to flip the device over to get into the correct orientation

Using the Philips #00 Screwdriver, unscrew and remove the four 9mm black screws on the base plate of the device.

Make sure to keep these screws in a safe location so you don’t lose them

1024

Step 2

  • Using the plastic opening tool, insert into the crack between the base plate and the main body of the device
  • Using a lever like motion, push the opening tool down thus lifting the plate
  • You will need to use your fingers to lift the base plate off the main body of the device
  • The motherboard is directly underneath the base plate

Using the plastic opening tool, insert into the crack between the base plate and the main body of the device

Using a lever like motion, push the opening tool down thus lifting the plate

You will need to use your fingers to lift the base plate off the main body of the device

The motherboard is directly underneath the base plate

Step 3

              Auxiliary Port
  • Using the Philips #00 screwdriver, unscrew and remove the two silver 10mm screws holding the motherboard
  • Don’t misplace the screws! Keep them in a safe place while working on the device
  • Make sure to ground yourself prior to continuing at this point

Using the Philips #00 screwdriver, unscrew and remove the two silver 10mm screws holding the motherboard

Don’t misplace the screws! Keep them in a safe place while working on the device

Make sure to ground yourself prior to continuing at this point

Step 4

  • Using the plastic opening tool, pull the motherboard out of the casing
  • Make sure to lift it out at an angle to the back, as the plastic power switch is attached to the board and can be broken

Using the plastic opening tool, pull the motherboard out of the casing

Make sure to lift it out at an angle to the back, as the plastic power switch is attached to the board and can be broken

Step 5

  • Desolder the 5 points holding the auxiliary port to the motherboard
  • Once complete, it’s as simple as lifting the port from the board

Desolder the 5 points holding the auxiliary port to the motherboard

Once complete, it’s as simple as lifting the port from the board

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Ryan Edwards

Member since: 03/21/2017

331 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team S3-G6, Botvin Spring 2017                        

                                                  Member of UMass Dartmouth, Team S3-G6, Botvin Spring 2017 



                    UMASSD-BOTVIN-S17S3G6                     


                                            2 Members                     


                                            5 Guides authored