Ihome Iavs16 Power Board Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Power Board
4 steps

Flags

BackiHome iAVS16
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Since the iHome iAVS16 is a compact device, any following replacement guide will use this guide as well in order to access the rest of the device.

What you need

Step 1

              Power Board

Remove the four 1.7 mm Phillips #0 screws located on the bottom of the device.
Lift up the bottom of the device.
Carefully lift the bottom of the device up as to not damage the ribbon cable connecting it.

Remove the four 1.7 mm Phillips #0 screws located on the bottom of the device.

Lift up the bottom of the device.

Carefully lift the bottom of the device up as to not damage the ribbon cable connecting it.

1024

Step 2

Remove the two 1.7 mm Phillips #0 screws holding the white face place onto the inside of the device’s bottom.
Using an iFixit opening tool on the side without the black adhesive, carefully lift up the white face plate.
Lifting too quickly could damage the ribbon cable still attached.

Remove the two 1.7 mm Phillips #0 screws holding the white face place onto the inside of the device’s bottom.

Using an iFixit opening tool on the side without the black adhesive, carefully lift up the white face plate.

Lifting too quickly could damage the ribbon cable still attached.

Step 3

Using the tweezers, lift up on the black tab holding the ribbon cable down.
Carefully pull the ribbon cable back and out of the slot.

Using the tweezers, lift up on the black tab holding the ribbon cable down.

Carefully pull the ribbon cable back and out of the slot.

Step 4

Remove the two 1.7 mm Phillips #0 screws holding the power board in.
Carefully flip the board over.
Remove the red connector from its socket with a pair of tweezers.

Remove the two 1.7 mm Phillips #0 screws holding the power board in.

Carefully flip the board over.

Remove the red connector from its socket with a pair of tweezers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Ashley Famularo

Member since: 10/25/2019

181 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UMass Dartmouth, Team S1-G7, O'Connell Fall 2019                        

                                                  Member of UMass Dartmouth, Team S1-G7, O'Connell Fall 2019 



                    UMASSD-O'CONNELL-F19S1G7                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team