Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

1

  • Probes
  • 6 steps

Flags

0

  • BackiDevices iGrill

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Probes
  • Remove the back plastic cover from the device; this should allow you access to the batteries.

Remove the back plastic cover from the device; this should allow you access to the batteries.

1024

Step 2

  • Remove the batteries from the device.

Remove the batteries from the device.

Step 3

  • Remove five black 10 mm Phillips #0 screws from the back side of the device.
  • Remove two silver-colored 5 mm screws using a Phillips screwdriver. The screws are located on the left side of the internal cover.
  • Remove the accompanying plastic tabs under the screws.
  • Gently pull off the back cover from the device.

Remove five black 10 mm Phillips #0 screws from the back side of the device.

Remove two silver-colored 5 mm screws using a Phillips screwdriver. The screws are located on the left side of the internal cover.

Remove the accompanying plastic tabs under the screws.

Gently pull off the back cover from the device.

Step 4

  • If you have not removed the 2 silver-colored screws; you must remove them now.
  • Remove the metal terminals from the battery slot closest you.
  • Pull the remaining metal terminals out of their slots. Position them such that when removing the internal cover they will not be caught.
  • Remove the internal cover.

If you have not removed the 2 silver-colored screws; you must remove them now.

Remove the metal terminals from the battery slot closest you.

Pull the remaining metal terminals out of their slots. Position them such that when removing the internal cover they will not be caught.

Remove the internal cover.

Step 5

  • After the internal plastic case has been removed, you will have access to the probe contacts.
  • You should then insert the probes to check their connection to the probe terminals.

After the internal plastic case has been removed, you will have access to the probe contacts.

You should then insert the probes to check their connection to the probe terminals.

Step 6

  • Using a pair of tweezers, bend the probe contacts back in place. The tweezers will touch the probe terminals when inserted.

Using a pair of tweezers, bend the probe contacts back in place. The tweezers will touch the probe terminals when inserted.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Michelle Nguyen

Member since: 02/16/2016

204 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       IUPUI, Team 3-4, Harley Spring 2016                        

                                                  Member of IUPUI, Team 3-4, Harley Spring 2016 



                    IUPUI-HARLEY-S16S3G4                     


                                            4 Members                     


                                            4 Guides authored