Idevices Igrill Power Delivery Wires And Springs Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Power Delivery Wires and Springs
7 steps

Flags

BackiDevices iGrill
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power Delivery Wires and Springs

Place the front screen of the device on a flat surface, this allows access to the back cover. Remove the back cover from the device to access the batteries.

Place the front screen of the device on a flat surface, this allows access to the back cover. Remove the back cover from the device to access the batteries.

1024

Step 2

Remove the batteries from the device, allowing you to access the screws necessary for removal of the back panel.

Remove the batteries from the device, allowing you to access the screws necessary for removal of the back panel.

Step 3

Remove five black 10 mm Phillips #0 screws from the back side of the device.
Remove two silver-colored 5 mm Phillips screws from the left side of the internal cover.

Remove five black 10 mm Phillips #0 screws from the back side of the device.

Remove two silver-colored 5 mm Phillips screws from the left side of the internal cover.

Step 4

Gently and slowly pull the back cover off of the iGrill, exposing the power cables to the motherboard.

Gently and slowly pull the back cover off of the iGrill, exposing the power cables to the motherboard.

Step 5

Gently pull the metal terminals to the batteries out of their plastic holders.
Position the metal terminals such that you will be able to pull the plastic component that holds the batteries away from the motherboard.
Remove the internal cover from the device.

Gently pull the metal terminals to the batteries out of their plastic holders.

Position the metal terminals such that you will be able to pull the plastic component that holds the batteries away from the motherboard.

Remove the internal cover from the device.

Step 6

After you have peeled back the rear plastic covering, you will have access to the motherboard.

After you have peeled back the rear plastic covering, you will have access to the motherboard.

Step 7

From here, you will have access to both the metal terminals of the power transfer wires and the soldering points of the power transfer wires to the motherboard.
If any of these connections have been broken, repair them with a solder and soldering wire.

From here, you will have access to both the metal terminals of the power transfer wires and the soldering points of the power transfer wires to the motherboard.

If any of these connections have been broken, repair them with a solder and soldering wire.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    Kyle McElyea

Member since: 02/16/2016

259 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       IUPUI, Team 3-4, Harley Spring 2016                        

                                                  Member of IUPUI, Team 3-4, Harley Spring 2016 



                    IUPUI-HARLEY-S16S3G4                     


                                            4 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team