Difficulty

Easy

Steps

9

Time Required

Suggest a time??

Sections

2

  • Battery
  • 2 steps
  • Keyboard
  • 7 steps

Flags

0

  • BackiBook G4 14" 933 MHz-1.33 GHz

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

Use a coin to rotate the battery locking screw 90 degrees clockwise.

1024

Step 2

  • Lift the battery out of the computer.

Lift the battery out of the computer.

Step 3

              Keyboard
  • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.
  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. The locking screw is in between the F5 and F6 keys and is a clear piece of plastic.
  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. The locking screw is in between the F5 and F6 keys and is a clear piece of plastic.

Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Step 4

  • If the computer has an AirPort card installed, follow the next three steps to remove it.
  • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

If the computer has an AirPort card installed, follow the next three steps to remove it.

Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

Step 5

  • Grasp the clear plastic tab on the AirPort card and pull toward the display.

Grasp the clear plastic tab on the AirPort card and pull toward the display.

Step 6

  • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

Step 7

  • Remove the four silver Phillips screws that secure the RAM shield.

Remove the four silver Phillips screws that secure the RAM shield.

Step 8

  • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Step 9

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.
  • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

Make sure that you reconnect the keyboard cable before replacing the RAM shield.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Attached Documents

  • iBook-G4-14"-Screw-Guide.pdf
  • PDF - 721.28 kb
  • View

iBook-G4-14"-Screw-Guide.pdf

PDF - 721.28 kb

Author

                                      with 6 other contributors 


                    iRobot

Member since: 09/24/2009

1 Reputation

                                      646 Guides authored                  



                       Badges:
                       36





                                                        +33 more badges