Ibook G3 Clamshell Airport Card Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          5 - 15 minutes            

Sections

2

• Battery
• 1 step
• Airport Card
• 3 steps

Flags

0

• BackiBook G3 Clamshell

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Use a coin to turn both battery locking screws 90 degrees to the left.
• Remove the battery cover.
• Remove the battery from the computer by pulling up on the plastic tab.

Use a coin to turn both battery locking screws 90 degrees to the left.

Remove the battery cover.

Remove the battery from the computer by pulling up on the plastic tab.

1024

Step 2

              Airport Card               

• Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free. Note that the keyboard ribbon is still attached to the logic board, so you cannot completely remove the keyboard yet.
• If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (between F4 and F5 key) 180 degrees in either direction and try again.
• Rotate the keyboard away from the screen and rest it face-down on the trackpad area.

Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free. Note that the keyboard ribbon is still attached to the logic board, so you cannot completely remove the keyboard yet.

If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (between F4 and F5 key) 180 degrees in either direction and try again.

Rotate the keyboard away from the screen and rest it face-down on the trackpad area.

Step 3

• If your computer does not have an airport card, you can skip the next two steps.
• Grasp the clear plastic tab on the airport card and pull up and toward the display.

If your computer does not have an airport card, you can skip the next two steps.

Grasp the clear plastic tab on the airport card and pull up and toward the display.

Step 4

• Hold the airport card in one hand and use your other hand to remove the antenna cable.

Hold the airport card in one hand and use your other hand to remove the antenna cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      18 other people completed this guide.                                             

Attached Documents

• iBook-Clamshell-Screw-Guide.pdf
• PDF - 480.93 kb
• View

iBook-Clamshell-Screw-Guide.pdf

PDF - 480.93 kb

Author

                                      with 5 other contributors 

                    iRobot                     

Member since: 09/24/2009

1 Reputation

                                      646 Guides authored                  



                       Badges:
                       36





                                                        +33 more badges