Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

2

  • Battery
  • 1 step
  • Rear Display Bezel
  • 6 steps

Flags

0

  • BackiBook G3 14"

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Lift the battery out of the computer.

Use a coin to rotate the battery locking screw 90 degrees clockwise.

Lift the battery out of the computer.

1024

Step 2

              Rear Display Bezel
  • Use a 1.5 mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).
  • If you don’t have a 1.5 mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you’ll be more likely to strip the screws.

Use a 1.5 mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

If you don’t have a 1.5 mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you’ll be more likely to strip the screws.

Step 3

  • Insert the flat end of a spudger perpendicular to the face of the display into the gap between the front and rear bezels near the upper left corner of the display.
  • Rotate the spudger away from the display to pry the rear bezel off the front bezel.

Insert the flat end of a spudger perpendicular to the face of the display into the gap between the front and rear bezels near the upper left corner of the display.

Rotate the spudger away from the display to pry the rear bezel off the front bezel.

Step 4

  • Run your spudger along the top edge of the front display bezel to evenly separate the two bezels.

Run your spudger along the top edge of the front display bezel to evenly separate the two bezels.

Step 5

  • Working down from the upper left corner, use the flat end of a spudger to pry the rear bezel away from the left edge of the display.

Working down from the upper left corner, use the flat end of a spudger to pry the rear bezel away from the left edge of the display.

Step 6

  • Use the flat end of a spudger to pry the rear bezel away from the right edge of the display.
  • If necessary, pry along the bottom edge of the rear bezel to separate it from the display assembly.

Use the flat end of a spudger to pry the rear bezel away from the right edge of the display.

If necessary, pry along the bottom edge of the rear bezel to separate it from the display assembly.

Step 7

  • Lift the rear bezel off the display assembly.

Lift the rear bezel off the display assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Andrew Bookholt

575,478 Reputation

                                      618 Guides authored                  



                       Badges:
                       47







                                                        +44 more badges