Difficulty

Moderate

Steps

7

Time Required

                          5 - 10 minutes

Sections

3

  • Battery
  • 2 steps
  • Palm Rest
  • 3 steps
  • RAM
  • 2 steps

Flags

2

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackIBM Thinkpad T60

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.
  • Use your finger to slide the tab to the right to unlock the battery.

Turn the computer over to see the small tab on the battery located near the top of the Thinkpad.

Use your finger to slide the tab to the right to unlock the battery.

1024

Step 2

  • Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad.
  • The battery is now disconnected.

Once the tab is in the unlocked position (far right), pull the battery outwards away from the Thinkpad.

The battery is now disconnected.

Step 3

              Palm Rest
  • Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.

Using a #0 Phillips screwdriver, remove the four 17.0 mm screws.

Step 4

  • Turn the computer back over, so the keyboard is facing upwards.
  • Open the display to access the palm rest. Apply pressure to the sides of the palm rest so that it bends upwards in the middle. Gently lift away from the computer.

Turn the computer back over, so the keyboard is facing upwards.

Open the display to access the palm rest. Apply pressure to the sides of the palm rest so that it bends upwards in the middle. Gently lift away from the computer.

Step 5

  • Slightly lift the palm rest away from the computer.
  • The touchpad’s data cable connects the palm rest to the base unit. BE CAREUL!
  • Detach the connector by pulling upwards on the white tab.

Slightly lift the palm rest away from the computer.

The touchpad’s data cable connects the palm rest to the base unit. BE CAREUL!

Detach the connector by pulling upwards on the white tab.

Step 6

              RAM
  • Press out the two tabs on either side of the card at the same time.
  • The memory card will slide upwards at a 20 degree angle.

Press out the two tabs on either side of the card at the same time.

The memory card will slide upwards at a 20 degree angle.

Step 7

  • Remove the memory card from the slot by pulling perpendicular to the slot.

Remove the memory card from the slot by pulling perpendicular to the slot.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      13 other people completed this guide.

Author

                                      with 10 other contributors 


                    Cody Kratochvil

Member since: 01/11/2013

506 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team 7-9, Maness Winter 2013                        

                                                  Member of Cal Poly, Team 7-9, Maness Winter 2013 



                    CPSU-MANESS-W13S7G9                     


                                            4 Members                     


                                            16 Guides authored

Keyten Martodikromo - May 30, 2016

Reply

God daamm im d