Difficulty

Moderate

Steps

9

Time Required

                          5 - 10 minutes

Sections

2

  • Battery
  • 3 steps
  • Hard Drive Disk
  • 6 steps

Flags

1

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

  • BackIBM ThinkPad 600E

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the laptop over and find the battery latch.

Flip the laptop over and find the battery latch.

1024

Step 2

  • Move the latch to the side with the unlocked symbol.

Move the latch to the side with the unlocked symbol.

Step 3

  • Pry the battery out using your fingers.

Pry the battery out using your fingers.

Step 4

              Hard Drive Disk
  • Put on the anti-static wrist trap and clip it to a large metal object.
  • If you do not have an anti-static wristband, make sure to touch a large metal object to ground yourself before beginning to work on your replacement. Occasionally touch the metal object.

Put on the anti-static wrist trap and clip it to a large metal object.

If you do not have an anti-static wristband, make sure to touch a large metal object to ground yourself before beginning to work on your replacement. Occasionally touch the metal object.

Step 5

  • Using a coin, remove the coin screw by turning counterclockwise.
  • It’s best to use a thicker coin, such as a nickel.

Using a coin, remove the coin screw by turning counterclockwise.

It’s best to use a thicker coin, such as a nickel.

Step 6

  • Using a plastic spudger, pry off the plastic cover by pulling it out.

Using a plastic spudger, pry off the plastic cover by pulling it out.

Step 7

  • Utilizing your fingers, untuck the tab and pull to remove the hard drive.

Utilizing your fingers, untuck the tab and pull to remove the hard drive.

Step 8

  • Using a screwdriver, remove the screws by turning them counterclockwise to remove the bracket.
  • four 3mm PH0 screws
  • The metal bracket is still attached with a weak adhesive tape, gently pry it off with a spudger.

Using a screwdriver, remove the screws by turning them counterclockwise to remove the bracket.

four 3mm PH0 screws

The metal bracket is still attached with a weak adhesive tape, gently pry it off with a spudger.

Step 9

  • The top plastic piece is adhered with a weak adhesive. Gently pry it off with a spudger.

The top plastic piece is adhered with a weak adhesive. Gently pry it off with a spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 5 other contributors 


                    Kevin Nguyen

Member since: 10/04/2016

710 Reputation

                                      4 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       USF Tampa, Team 1-4, Nance Fall 2016                        

                                                  Member of USF Tampa, Team 1-4, Nance Fall 2016 



                    USFT-NANCE-F16S1G4                     


                                            4 Members                     


                                            12 Guides authored