Difficulty

Easy

Steps

4

Time Required

                          10 minutes

Sections

1

  • Humax RM-H01U Remote Disassembly
  • 4 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackHumax RM-H01U Remote

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              The Humax RM-H01U remote
  • The remote has a bottom and top part. They are held together with plastic clips.
  • Don’t forget to remove the battery, just for good measure.

The remote has a bottom and top part. They are held together with plastic clips.

Don’t forget to remove the battery, just for good measure.

1024

Step 2

              Opening using a spudger
  • Use a spudger, prying tool or a flatbed screwdriver to pry open the two halves. Start at the center.
  • The two halves are clamped together firmly.
  • Work your way to the front, and then back again on the other side.
  • See the next step for the location of the clips.

Use a spudger, prying tool or a flatbed screwdriver to pry open the two halves. Start at the center.

The two halves are clamped together firmly.

Work your way to the front, and then back again on the other side.

See the next step for the location of the clips.

Step 3

              Clip locations
  • The clips are located 3 centimeters apart. The first clip is 1 centimeter from the front of the remote.
  • The hooks of the clips are on the bottom halve of the remote and face inward.
  • The top halve of the remote has indents where the clips grab into.

The clips are located 3 centimeters apart. The first clip is 1 centimeter from the front of the remote.

The hooks of the clips are on the bottom halve of the remote and face inward.

The top halve of the remote has indents where the clips grab into.

Step 4

              All parts of the remote
  • These are all the parts.
  • I cleaned all parts with a toothbrush first.
  • Then I cleaned the PCB and the back of the silicone buttons with pure alcohol.
  • Make sure not to brush too hard! You might remove the carbon layer that is applied. (It’s the carbon layer that makes the electrical connection, so it’s essential).

These are all the parts.

I cleaned all parts with a toothbrush first.

Then I cleaned the PCB and the back of the silicone buttons with pure alcohol.

Make sure not to brush too hard! You might remove the carbon layer that is applied. (It’s the carbon layer that makes the electrical connection, so it’s essential).

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jurrie

Member since: 05/07/2021

395 Reputation

                                      3 Guides authored                  



                       Badges:
                       2