Difficulty

Moderate

Steps

6

Time Required

                          45 minutes

Sections

3

  • Back Cover
  • 3 steps
  • Motherboard Shield
  • 2 steps
  • Headphone Jack
  • 1 step

Flags

0

  • BackHuawei P9 Lite

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Use an opening pick to unclip the rear cover, starting from the bottom corner.
  • Work your way around counterclockwise and carefully pry the plastic tabs open one by one.

Use an opening pick to unclip the rear cover, starting from the bottom corner.

Work your way around counterclockwise and carefully pry the plastic tabs open one by one.

1024

Step 2

  • There is adhesive underneath the back cover that holds it to the battery and the metal plate at the top.
  • Be careful with the flex cable at the right hand side.
  • Twist the opening pick to lever the back cover away and loosen it from the adhesive.

There is adhesive underneath the back cover that holds it to the battery and the metal plate at the top.

Be careful with the flex cable at the right hand side.

Twist the opening pick to lever the back cover away and loosen it from the adhesive.

Step 3

  • When the back cover is freed from the adhesive you can pop it off by hand completely.

When the back cover is freed from the adhesive you can pop it off by hand completely.

Step 4

              Motherboard Shield
  • Remove the nine Phillips #00 screws that secure the metal shield plate.
  • Some screws may be covered with tamper proof stickers. Remove them to ensure a proper seating for your driver.

Remove the nine Phillips #00 screws that secure the metal shield plate.

Some screws may be covered with tamper proof stickers. Remove them to ensure a proper seating for your driver.

Step 5

  • Do not remove the shield plate yet, it is attached by a connector and an adhered cable.
  • Use a spudger to disconnect the fingerprint sensor from the motherboard.
  • Peel the NFC antenna cable off of the metal plate.

Do not remove the shield plate yet, it is attached by a connector and an adhered cable.

Use a spudger to disconnect the fingerprint sensor from the motherboard.

Peel the NFC antenna cable off of the metal plate.

Step 6

              Headphone Jack
  • Disconnect the headphone jack with a spudger.
  • Take the headphone jack out of its recess.

Disconnect the headphone jack with a spudger.

Take the headphone jack out of its recess.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      8 other people completed this guide.

Author

                                      with 1 other contributor 


                    Dominik Schnabelrauch

Member since: 11/23/2016

158,135 Reputation

                                      649 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored