This guide has more recent changes. Switch to the latest unverified version.
Difficulty
Moderate
Steps
5
Time Required
30 minutes
Sections
1
- Batterie
- 5 steps
Flags
3
Grammar Police
Embrace your inner English teacher and help improve this guide’s grammar!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackHuawei Mate 9 Lite
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Batterie
- Heat the back of the device (e.g. with a warm bottle).
- Then use a suction cup to lift the back a bit and insert a pick into the gap. Guide the plectrum once around the smartphone and loosen the glue, then remove the back cover.
- Note the cable for the fingerprint sensor.
- The back is made of a quite flexible plastic. Thus, you cannot easily destroy the back
- There is a sticker with the serial number on the back. This has to be removed so that the suction cup holds well.
Heat the back of the device (e.g. with a warm bottle).
Then use a suction cup to lift the back a bit and insert a pick into the gap. Guide the plectrum once around the smartphone and loosen the glue, then remove the back cover.
Note the cable for the fingerprint sensor.
The back is made of a quite flexible plastic. Thus, you cannot easily destroy the back
There is a sticker with the serial number on the back. This has to be removed so that the suction cup holds well.
1024
Step 2
- Loosen the two screws that fix the cable on the right above the battery.
- Disconnect the cable and the cables attached to the same connector from the mainboard.
- Use a non-conductive object for this.
Loosen the two screws that fix the cable on the right above the battery.
Disconnect the cable and the cables attached to the same connector from the mainboard.
Use a non-conductive object for this.
Step 3
- Now release the cable on the left side.
- First, carefully bend the metal bracket that holds the cable on the right side a little to the side and then loosen the screw that holds the cable.
- Then carefully pull the cable upwards.
Now release the cable on the left side.
First, carefully bend the metal bracket that holds the cable on the right side a little to the side and then loosen the screw that holds the cable.
Then carefully pull the cable upwards.
Step 4
- The battery is very firmly glued to the case.
- Be careful when removing it!
- I put the phone on a hot water bottle with the display facing down. This is not the best solution, but it works.
The battery is very firmly glued to the case.
Be careful when removing it!
I put the phone on a hot water bottle with the display facing down. This is not the best solution, but it works.
Step 5
- To reassemble the smartphone, you first need to remove the adhesive residue that is present around the frame.
- Then follow the last steps backwards.
- Do not bend the metal bracket for the left cable back until you have already screwed the cable.
To reassemble the smartphone, you first need to remove the adhesive residue that is present around the frame.
Then follow the last steps backwards.
Do not bend the metal bracket for the left cable back until you have already screwed the cable.
Follow the instructions in reverse order to reassemble the device.
Cancel: I did not complete this guide.
oldturkey03 is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
oldturkey03
Author
with 2 other contributors
Malte Kerl
Member since: 06/04/2022
121 Reputation
1 Guide authored
Badges:
2
