Difficulty

Moderate

Steps

4

Time Required

                          2 - 10 minutes

Sections

1

  • USB Port
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackHuawei Mate 10 lite

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

This guide will show you how to replace the USB port.

What you need

Step 1

              Remove SIM card
  • Remove the SIM card by inserting a paper clip or a special tool into the hole on the SIM card tray until it comes out.

Remove the SIM card by inserting a paper clip or a special tool into the hole on the SIM card tray until it comes out.

1024

Step 2

              Open the housing
  • Remove the Torx T2 screws at the bottom of the case (next to the USB port)
  • Insert the opening tool on the lower end and in between the housing
  • Run the opening tool along the sides to open it
  • Lay the device face down and lift the back cover to the left

Remove the Torx T2 screws at the bottom of the case (next to the USB port)

Insert the opening tool on the lower end and in between the housing

Run the opening tool along the sides to open it

Lay the device face down and lift the back cover to the left

Step 3

              Remove the cables and screws
  • Red: Phillips #00 screws
  • Blue: Use the spudger to remove the covers
  • Use a spudger to remove the cable going to the back panel and those going over the battery
  • Yellow: Detach the antenna cable from the USB board

Red: Phillips #00 screws

Blue: Use the spudger to remove the covers

Use a spudger to remove the cable going to the back panel and those going over the battery

Yellow: Detach the antenna cable from the USB board

Step 4

              Detach the USB board
  • lift the speaker out by lifting it from the right or left. Warning: this may require some force as the speaker is glued.
  • Lift the USB board out .
  • If there are no silicone dust covers on the replacement part (like here on the aux port), then replace those from donor parts and place them on the new replacement part in the same orientation. This cover also serves to ensure that no light shines through the openings

lift the speaker out by lifting it from the right or left. Warning: this may require some force as the speaker is glued.

Lift the USB board out .

If there are no silicone dust covers on the replacement part (like here on the aux port), then replace those from donor parts and place them on the new replacement part in the same orientation. This cover also serves to ensure that no light shines through the openings

Follow this guide in reversed order to reassemble your device.

Cancel: I did not complete this guide.

        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 


                    Maximilian Deisz

Member since: 10/04/2021

326 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge