Huawei Ideos S7 Slim Logic Board Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 8 minutes

Sections

Battery
2 steps
Logic Board
5 steps

Flags

BackHuawei Ideos S7 Slim
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Place the tablet on a flat clear surface to keep the screen safe.
Slide the larger portion of the back cover off the tablet.
This will reveal the battery.

Place the tablet on a flat clear surface to keep the screen safe.

Slide the larger portion of the back cover off the tablet.

This will reveal the battery.

1024

Step 2

Lift the battery out with your finger.
Make sure you use the slot near the bottom of the device as shown. Trying to lift from anywhere else will not work and may damage the battery or the device.

Lift the battery out with your finger.

Make sure you use the slot near the bottom of the device as shown. Trying to lift from anywhere else will not work and may damage the battery or the device.

Step 3

              Logic Board

Using a plastic opening tool, pry off the top cover casing gently by moving the tool along all three sides.

Using a plastic opening tool, pry off the top cover casing gently by moving the tool along all three sides.

Step 4

With a T5 hexagonal head, remove the nine black 2.5 mm torx screws. Place them carefully aside on the magnetic mat.

With a T5 hexagonal head, remove the nine black 2.5 mm torx screws. Place them carefully aside on the magnetic mat.

Step 5

Using a plastic opening tool, pry off the back casing gently on each side of the tablet.

Using a plastic opening tool, pry off the back casing gently on each side of the tablet.

Step 6

Using a Phillips #00 screwdriver, remove the following screws:
Four 5mm wide grey Phillips screws on the logic board.
One of the 5mm screws is hidden under the circular white tape in the center of the logic board.
Seven 3mm small grey Phillips screws (four on one side, three on the other) from the black side casing.

Using a Phillips #00 screwdriver, remove the following screws:

Four 5mm wide grey Phillips screws on the logic board.

One of the 5mm screws is hidden under the circular white tape in the center of the logic board.

Seven 3mm small grey Phillips screws (four on one side, three on the other) from the black side casing.

Step 7

Disconnect the five cables connected to the logic board and then carefully lift the logic board out of the casing.

Disconnect the five cables connected to the logic board and then carefully lift the logic board out of the casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Gregory Philip

Member since: 09/21/2016

585 Reputation

                                      4 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       UC Davis, Team 1-1, Oliver Fall 2016                        

                                                  Member of UC Davis, Team 1-1, Oliver Fall 2016 



                    UCD-OLIVER-F16S1G1                     


                                            5 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team