Huawei Honor 6X Rear Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          40 - 45 minutes

Sections

SIM Card
4 steps
Back Cover
5 steps
Rear Camera
2 steps

Flags

BackHuawei Honor 6x
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              SIM Card

Turn off the device.

Turn off the device.

1024

Step 2

Insert the SIM Card Eject Tool into the SIM card tray hole.
Press the eject tool into the hole until the tray clicks open.

Insert the SIM Card Eject Tool into the SIM card tray hole.

Press the eject tool into the hole until the tray clicks open.

Step 3

Remove the SIM tray from the device using two fingers.
When reinserting the SIM card, be sure it is properly aligned with the SIM tray.

Remove the SIM tray from the device using two fingers.

When reinserting the SIM card, be sure it is properly aligned with the SIM tray.

Step 4

Remove the SIM card from the compartment using two fingers.

Remove the SIM card from the compartment using two fingers.

Step 5

              Back Cover

Insert a plastic opening tool into the Micro USB charging port with the the angled side of the tool facing the screen.
Pry the screen off the back of the phone by pushing down on the opening tool.

Insert a plastic opening tool into the Micro USB charging port with the the angled side of the tool facing the screen.

Pry the screen off the back of the phone by pushing down on the opening tool.

Step 6

Slide the opening tool or spudger along the bottom of the phone and around the edge.

Slide the opening tool or spudger along the bottom of the phone and around the edge.

Step 7

Once three sides of the screen are detached, pry the phone apart using two hands.
When separating the back panel from the screen, do not pull them too far apart. There is an interconnect that is attached to both sides that could break, or tear, if pulled too far.

Once three sides of the screen are detached, pry the phone apart using two hands.

When separating the back panel from the screen, do not pull them too far apart. There is an interconnect that is attached to both sides that could break, or tear, if pulled too far.

Step 8

Remove the five 4mm Phillips #00 screws using a screwdriver.

Remove the five 4mm Phillips #00 screws using a screwdriver.

Step 9

Remove the motherboard cover from the device using a spudger or your fingers.

Remove the motherboard cover from the device using a spudger or your fingers.

Step 10

              Rear Camera

Pry the two connectors off by wedging a spudger, or your finger, underneath the connector.

Pry the two connectors off by wedging a spudger, or your finger, underneath the connector.

Step 11

Gently remove the camera assembly using a spudger or two fingers.

Gently remove the camera assembly using a spudger or two fingers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    M Morgan

Member since: 10/08/2018

641 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S13-G5, White Fall 2018                        

                                                  Member of Cal Poly, Team S13-G5, White Fall 2018 



                    CPSU-WHITE-F18S13G5                     


                                            4 Members                     


                                            14 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team