Difficulty

Easy

Steps

6

Time Required

                          10 minutes

Sections

1

  • Rear Facing Camera
  • 6 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHuawei Ascend Y300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Rear Facing Camera
  • Place the phone screen down on a flat surface. Underneath the camera there will be a indentation, place your thumb or pointer finger on the indentation and pull gently up towards you. The back of the phone should pop off easily.

Place the phone screen down on a flat surface. Underneath the camera there will be a indentation, place your thumb or pointer finger on the indentation and pull gently up towards you. The back of the phone should pop off easily.

1024

Step 2

  • Underneath the back of the phone you will find the battery. The battery is located in the middle of the phone’s inner backing. By the battery you will find a similar indentation; place your thumb in the indentation and lift the battery towards you. The battery will come right out.

Underneath the back of the phone you will find the battery. The battery is located in the middle of the phone’s inner backing. By the battery you will find a similar indentation; place your thumb in the indentation and lift the battery towards you. The battery will come right out.

Step 3

  • Along the edges of the phone you will find 8 screws, to remove these screws use a screwdriver( T5 if you are using the screwdriver found in the ifixit 54 bit driver kit)
  • Take the screws out by twisting left and set them in a spot where you will not lose them.

Along the edges of the phone you will find 8 screws, to remove these screws use a screwdriver( T5 if you are using the screwdriver found in the ifixit 54 bit driver kit)

Take the screws out by twisting left and set them in a spot where you will not lose them.

Step 4

  • Use the blue plastic opening tool by sliding it along the edges of the phone to pull back the frame.

Use the blue plastic opening tool by sliding it along the edges of the phone to pull back the frame.

Step 5

  • After removing the phone’s frame, you will see the camera placed in a metallic cube, to remove the cube lift the edge gently and pull to the left.
  • You will notice the cube is attached to a copper ribbon, do not separate the cube from the ribbon!! it is attached.

After removing the phone’s frame, you will see the camera placed in a metallic cube, to remove the cube lift the edge gently and pull to the left.

You will notice the cube is attached to a copper ribbon, do not separate the cube from the ribbon!! it is attached.

Step 6

  • CONGRATULATIONS!!! you have successfully completed this guide, please share this guide with your friends
  • Yay! Party time don’t forget the bean dip

CONGRATULATIONS!!! you have successfully completed this guide, please share this guide with your friends

Yay! Party time don’t forget the bean dip

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Julie Vasquez

Member since: 11/30/2017

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Coast Union High School, Team S1-G4, Hartzell Fall 2017                        

                                                  Member of Coast Union High School, Team S1-G4, Hartzell Fall 2017 



                    CUHS-HARTZELL-F17S1G4                     


                                            2 Members                     


                                            2 Guides authored

Dan Hartzell - Jan 24, 2018

Reply

Very specific and thorough. Wonderful job ladies!