Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

1

  • Camera
  • 6 steps

Flags

0

  • BackHuawei Ascend XT

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The following tools will be needed for this replacement:

  • SpudgerOpening tool0.8 SIM Eject BitBit DriverPhillips head bit

What you need

Step 1

              Camera
  • Use the 0.8 Sim driver bit to remove the SIM tray by inserting it into the hole on the side of the device.
  • Once the hole is pressed in firm, the SIM tray will pop out. This allows you to grab it and extract it from the device.

Use the 0.8 Sim driver bit to remove the SIM tray by inserting it into the hole on the side of the device.

Once the hole is pressed in firm, the SIM tray will pop out. This allows you to grab it and extract it from the device.

1024

Step 2

  • Make a thumbs-up and use it to grip the plastic opening tool with the flat end pointing in the direction of your thumb.
  • Place the flat end of the opening tool slightly inside the charging port and place your thumb on the back of the phone.
  • Press into the phone with your thumb while pulling the opening tool back with your fist to begin prying the back off.

Make a thumbs-up and use it to grip the plastic opening tool with the flat end pointing in the direction of your thumb.

Place the flat end of the opening tool slightly inside the charging port and place your thumb on the back of the phone.

Press into the phone with your thumb while pulling the opening tool back with your fist to begin prying the back off.

Step 3

  • Slide the flat end of the spudger along the edge of the device, prying off the back cover.
  • Carefully remove the back cover. This may be difficult due to glue on the inside.

Slide the flat end of the spudger along the edge of the device, prying off the back cover.

Carefully remove the back cover. This may be difficult due to glue on the inside.

Step 4

  • Use the Phillips head bit to remove 20 screws.

Use the Phillips head bit to remove 20 screws.

Step 5

  • Carefully pull off the speaker assembly.
  • Carefully pull off the antenna assembly.
  • Carefully pull off the top left tab.
  • Carefully remove the back plate assembly.

Carefully pull off the speaker assembly.

Carefully pull off the antenna assembly.

Carefully pull off the top left tab.

Carefully remove the back plate assembly.

Step 6

  • Carefully remove the camera wire tab from the mother board on the right side of the camera.
  • Remove the camera.
  • Replace the camera and rebuild.

Carefully remove the camera wire tab from the mother board on the right side of the camera.

Remove the camera.

Replace the camera and rebuild.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jimmy Shields

Member since: 09/24/2018

577 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       The Citadel Military College of South Carolina, Team S3-G8, Eggleston Fall 2018                        

                                                  Member of The Citadel Military College of South Carolina, Team S3-G8, Eggleston Fall 2018 



                    CMCSC-EGGLESTON-F18S3G8                     


                                            5 Members                     


                                            10 Guides authored