Difficulty

Moderate

Steps

11

Time Required

                          40 minutes

Sections

3

  • Battery
  • 1 step
  • Back Panel
  • 5 steps
  • Motherboard
  • 5 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHTC Wizard 200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • To expose the battery, remove the outer case with your fingernail.
  • Remove the battery by pulling the black tab.

To expose the battery, remove the outer case with your fingernail.

Remove the battery by pulling the black tab.

1024

Step 2

              Back Panel
  • Insert the flat end of the spudger into the two notches on the back of the camera cover and pry them up.

Insert the flat end of the spudger into the two notches on the back of the camera cover and pry them up.

Step 3

  • Work the spudger around the edges of the camera cover until it comes off.

Work the spudger around the edges of the camera cover until it comes off.

Step 4

  • Remove the four 6 mm screws with the T5 Torx screwdriver.
  • One of the screws is under the “void” sticker.

Remove the four 6 mm screws with the T5 Torx screwdriver.

One of the screws is under the “void” sticker.

Step 5

  • Insert the flat end of an iFixit opening tool between the side and inner covers to create a gap.
  • Work the tool around the edges until all the clips release.

Insert the flat end of an iFixit opening tool between the side and inner covers to create a gap.

Work the tool around the edges until all the clips release.

Step 6

  • Once all the clips are open, remove the inner panel from the phone.

Once all the clips are open, remove the inner panel from the phone.

Step 7

              Motherboard
  • Use the spudger to pry the camera off.

Use the spudger to pry the camera off.

Step 8

  • Using tweezers, flip the connector latch away from the motherboard.
  • Detach the flexible connection from under the connector latch.

Using tweezers, flip the connector latch away from the motherboard.

Detach the flexible connection from under the connector latch.

Step 9

  • Slide the keyboard into the open position.

Slide the keyboard into the open position.

Step 10

  • Lift the motherboard out of the case using the spudger.
  • Expose the underside of the motherboard using your hands.

Lift the motherboard out of the case using the spudger.

Expose the underside of the motherboard using your hands.

Step 11

  • Remove the flexible connection from the motherboard.
  • Caution: Removing the connection too fast may cause damage to the connection and cables.

Remove the flexible connection from the motherboard.

Caution: Removing the connection too fast may cause damage to the connection and cables.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Kyle Champ

Member since: 10/03/2011

225 Reputation

                                      12 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 20-27, Maness Fall 2011                        

                                                  Member of Cal Poly, Team 20-27, Maness Fall 2011 



                    CPSU-MANESS-F11S20G27                     


                                            4 Members                     


                                            24 Guides authored