Difficulty

Moderate

Steps

7

Time Required

                          2 - 5 minutes

Sections

2

  • Facerest
  • 1 step
  • Headstrap
  • 6 steps

Flags

0

  • BackHTC Vive Cosmos

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Make sure that the Vive Cosmos is powered off and disconnected from power before beginning disassembly.

What you need

Step 1

              Remove the facerest
  • Pull the bottom of the facerest straight away from the Vive Cosmos to unclip it from the Vive.
  • With the bottom unclipped, pull the top of the facerest away from the Vive to remove it.

Pull the bottom of the facerest straight away from the Vive Cosmos to unclip it from the Vive.

With the bottom unclipped, pull the top of the facerest away from the Vive to remove it.

1024

Step 2

              Unplug the audio connector
  • Twist the 3.5 mm audio connector counter-clockwise slightly and slide its cable out from under the plastic retaining clip.
  • Lift the audio connector straight up to unplug it.

Twist the 3.5 mm audio connector counter-clockwise slightly and slide its cable out from under the plastic retaining clip.

Lift the audio connector straight up to unplug it.

Step 3

              Remove the front headstrap pad
  • Grasp one end of the front headstrap pad and pull it away from the headstrap to remove it.
  • During reassembly, press the pads firmly against the headstrap, starting in the middle and moving toward the edges, until all the clips on the pads are completely seated in the headstrap. There should be no gaps between the pads and the headstrap.

Grasp one end of the front headstrap pad and pull it away from the headstrap to remove it.

During reassembly, press the pads firmly against the headstrap, starting in the middle and moving toward the edges, until all the clips on the pads are completely seated in the headstrap. There should be no gaps between the pads and the headstrap.

Step 4

              Remove the audio cables
  • Carefully lift the audio connector cable out of its slot in the front of the headstrap.

Carefully lift the audio connector cable out of its slot in the front of the headstrap.

Step 5

  • Carefully lift the audio interconnect cable out of its slot in the front of the headstrap.

Carefully lift the audio interconnect cable out of its slot in the front of the headstrap.

Step 6

              Remove the headstrap
  • Use a T5 Torx drive to remove the ten 4.1 mm long screws securing the headstrap.

Use a T5 Torx drive to remove the ten 4.1 mm long screws securing the headstrap.

Step 7

  • Remove the headstrap.

Remove the headstrap.

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Adam O'Camb

Member since: 04/11/2015

173,479 Reputation

                                      418 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges