Htc Smt 6175 Ear Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Battery
3 steps
Speaker
4 steps

Flags

BackHTC SMT 6175
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Case

First, flip the phone over so that the back is facing you.

First, flip the phone over so that the back is facing you.

1024

Step 2

Next, using both thumbs, carefully push the back side of the phone’s exterior up, removing it from the main section of the phone.
Set this piece aside until you need to reassemble the phone.

Next, using both thumbs, carefully push the back side of the phone’s exterior up, removing it from the main section of the phone.

Set this piece aside until you need to reassemble the phone.

Step 3

              Battery

Insert thumb and pointer finger into the notch above the battery. Pull the battery away from the rest of the phone and set it aside.

Insert thumb and pointer finger into the notch above the battery. Pull the battery away from the rest of the phone and set it aside.

Step 4

              Speaker

Next, choose the matching tool from your driver kit and remove the six screws found around the perimeter of the phone.
Once the screws are removed make sure to keep them in a safe place for reassembly.

Next, choose the matching tool from your driver kit and remove the six screws found around the perimeter of the phone.

Once the screws are removed make sure to keep them in a safe place for reassembly.

Step 5

Carefully pull off the back casing.
This can be difficult. Start by slowly pulling the back part from the front shell. As it starts to lift up, continue moving around the phone until it is in two separate pieces.

Carefully pull off the back casing.

This can be difficult. Start by slowly pulling the back part from the front shell. As it starts to lift up, continue moving around the phone until it is in two separate pieces.

Step 6

Next, remove the top screw.
Be careful! The LCD screen is still attached to the front of the motherboard by a flexible ribbon cable.

Next, remove the top screw.

Be careful! The LCD screen is still attached to the front of the motherboard by a flexible ribbon cable.

Step 7

Flip over the motherboard so that the front case is visible. Using a spudger, remove the speaker out of its holding cell.

Flip over the motherboard so that the front case is visible. Using a spudger, remove the speaker out of its holding cell.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Luke Plewa

Member since: 04/22/2011

116 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 25-29, Garner Spring 2011                        

                                                  Member of Cal Poly, Team 25-29, Garner Spring 2011 



                    CPSU-GARNER-S11S25G29                     


                                            3 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team