Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

2

  • Battery
  • 2 steps
  • Vibration Monitor
  • 6 steps

Flags

0

  • BackHTC Rezound

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use a plastic opening tool or your fingers to get into the groove between the cover and case. Remove the back covering so that the red battery is visible.

Use a plastic opening tool or your fingers to get into the groove between the cover and case. Remove the back covering so that the red battery is visible.

1024

Step 2

  • Remove the red battery to replace.

Remove the red battery to replace.

Step 3

              Vibration Monitor
  • Using a Torx T4 screwdriver, remove the six screws from the six spots shown in the photo.
  • Use a spudger to pry the casing from the phone.

Using a Torx T4 screwdriver, remove the six screws from the six spots shown in the photo.

Use a spudger to pry the casing from the phone.

Step 4

  • Gently remove casing from phone.

Gently remove casing from phone.

Step 5

  • Shown here is the vibration Monitor, this is what you will be replacing.

Shown here is the vibration Monitor, this is what you will be replacing.

Step 6

  • Remove the body of the monitor from the case attaching it to the motherboard.
  • Make sure to remove any potential obstruction that could be blocking the weight at the end!

Remove the body of the monitor from the case attaching it to the motherboard.

Make sure to remove any potential obstruction that could be blocking the weight at the end!

Step 7

  • Carefully disconnect the cable attached at the motherboard.

Carefully disconnect the cable attached at the motherboard.

Step 8

  • Insert the replacement’s cable into the same spot on the logic board! Then just set it back into the slot on the logic board and you are done!

Insert the replacement’s cable into the same spot on the logic board! Then just set it back into the slot on the logic board and you are done!

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Robin White

Member since: 01/29/2018

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of Alabama, Team S3-G12, Bedsole Spring 2018                        

                                                  Member of University of Alabama, Team S3-G12, Bedsole Spring 2018 



                    UA-BEDSOLE-S18S3G12                     


                                            4 Members                     


                                            7 Guides authored