Difficulty

Difficult

Steps

7

Time Required

                          1 hour

Sections

1

  • Screen
  • 7 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackHTC One X+

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Screen
  • Power off your device.
  • Insert a pin, paper clip, or very small piece of metal in the hole next to the micro sim card holder to remove it.
  • The sim card slot is located on the top edge of the device.

Power off your device.

Insert a pin, paper clip, or very small piece of metal in the hole next to the micro sim card holder to remove it.

The sim card slot is located on the top edge of the device.

1024

Step 2

  • Using plastic opening tools, pry open the bottom of the device first.
  • You will hear clicking sounds as the sides of the device detach from the screen.
  • Once both sides are detached, use the suction cup tool to remove the screen completely from the black encasing.

Using plastic opening tools, pry open the bottom of the device first.

You will hear clicking sounds as the sides of the device detach from the screen.

Once both sides are detached, use the suction cup tool to remove the screen completely from the black encasing.

Step 3

  • Remove the five 2.4 mm screws using a Phillips #000 screwdriver.
  • Remove the plastic cover.

Remove the five 2.4 mm screws using a Phillips #000 screwdriver.

Remove the plastic cover.

Step 4

  • Use a Phillips #000 screwdriver to remove the two 3.4 mm screws.
  • Remove the PCB board and antenna.

Use a Phillips #000 screwdriver to remove the two 3.4 mm screws.

Remove the PCB board and antenna.

Step 5

  • Use tweezers to disconnect the power button flex cable.

Use tweezers to disconnect the power button flex cable.

Step 6

  • Disconnect the battery’s six pin connector from the motherboard.
  • Remove the battery by pulling it upwards.

Disconnect the battery’s six pin connector from the motherboard.

Remove the battery by pulling it upwards.

Step 7

  • Disconnect the screen from the digitizer.
  • Use a plastic opening tool to gently disconnect the screen from the digitizer.
  • You may have to use heat to loosen adhesive securing the screen.

Disconnect the screen from the digitizer.

Use a plastic opening tool to gently disconnect the screen from the digitizer.

You may have to use heat to loosen adhesive securing the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Jason Melo

Member since: 08/26/2015

483 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 3-3, Eyestone Fall 2015                        

                                                  Member of USF Tampa, Team 3-3, Eyestone Fall 2015 



                    USFT-EYESTONE-F15S3G3                     


                                            3 Members                     


                                            10 Guides authored

Garrett Reyman - Dec 7, 2020

Reply

Man, this did nothing but break my International One X+. There were so many instructions missing.