Difficulty

Difficult

Steps

7

Time Required

                          50 minutes

Sections

1

  • Motherboard
  • 7 steps

Flags

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

  • BackHTC One X+

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard
  • Power off your device.
  • Insert a pin, paper clip, or very small piece of metal into the hole next to the micro sim card holder to remove it.
  • The Sim Card Slot is located on the top edge of the device.

Power off your device.

Insert a pin, paper clip, or very small piece of metal into the hole next to the micro sim card holder to remove it.

The Sim Card Slot is located on the top edge of the device.

1024

Step 2

  • Using plastic opening tools, pry open the bottom of the device first.
  • You will hear clicking sounds as the sides of the device detach from the screen.
  • Once both sides are detached use the suction cup tool to remove the screen completely from the black encasing.

Using plastic opening tools, pry open the bottom of the device first.

You will hear clicking sounds as the sides of the device detach from the screen.

Once both sides are detached use the suction cup tool to remove the screen completely from the black encasing.

Step 3

  • Remove the five 2.4mm screws using a Philips head screw driver and then remove the plastic cover.
  • Once you have disassembled your device the warranty will no longer be valid.

Remove the five 2.4mm screws using a Philips head screw driver and then remove the plastic cover.

Once you have disassembled your device the warranty will no longer be valid.

Step 4

  • Use the J000 Philips screw driver head to remove the screws.
  • Two 3.4mm Philips head screws
  • Remove the PCB board and antenna.

Use the J000 Philips screw driver head to remove the screws.

Two 3.4mm Philips head screws

Remove the PCB board and antenna.

Step 5

  • Use tweezers to disconnect the power button flex cable.
  • Disconnect the touch screen flex cable

Use tweezers to disconnect the power button flex cable.

Disconnect the touch screen flex cable

Step 6

  • Disconnect the battery from the logic board.
  • Six pin connector
  • Remove the battery by pulling upwards.

Disconnect the battery from the logic board.

Six pin connector

Remove the battery by pulling upwards.

Step 7

  • Disconnect the remaining two flex cables in a similar manner before completely removing the motherboard.
  • You may now remove the motherboard.

Disconnect the remaining two flex cables in a similar manner before completely removing the motherboard.

You may now remove the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Jason Melo

Member since: 08/26/2015

483 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 3-3, Eyestone Fall 2015                        

                                                  Member of USF Tampa, Team 3-3, Eyestone Fall 2015 



                    USFT-EYESTONE-F15S3G3                     


                                            3 Members                     


                                            10 Guides authored