Htc One Mini 2 Back Plate Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Back Plate
5 steps

Flags

BackHTC One Mini 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Sim and MicroSD Card

Insert the end of a paper clip into the holes on each side of the phone to eject the SIM card and Micro SD card.
Set the cardholders aside.

Insert the end of a paper clip into the holes on each side of the phone to eject the SIM card and Micro SD card.

Set the cardholders aside.

1024

Step 2

Heat up the top grey speaker plate with the iFixit iOpener for two minutes.

Heat up the top grey speaker plate with the iFixit iOpener for two minutes.

Step 3

              Front Plate

Use a metal spudger to pry up the left edge of the upper grey front plate.
Place the spudger between the inside white plastic edge and the grey plate. Do not pry between the two white plastic frames.
Don’t pry against the glass. Pry against only the left side as there is a delicate antenna under the plate.
Use the narrow plastic pry tool to carefully separate the black ribbon antenna from the grey plate.

Use a metal spudger to pry up the left edge of the upper grey front plate.

Place the spudger between the inside white plastic edge and the grey plate. Do not pry between the two white plastic frames.

Don’t pry against the glass. Pry against only the left side as there is a delicate antenna under the plate.

Use the narrow plastic pry tool to carefully separate the black ribbon antenna from the grey plate.

Step 4

Remove the 2mm screw with a T5 torx screwdriver head from the iFixit tool kit.

Remove the 2mm screw with a T5 torx screwdriver head from the iFixit tool kit.

Step 5

Use the plastic pry tool to pry around the edge of the phone.
Pry carefully around the card slots.
Slowly pull up from the right side of the screen like opening a book.
The plastic piece for the power button may fall out. Set it aside for reassembly.
Use the plastic spudger to peel the foam adhesive around the camera away from the back plate.

Use the plastic pry tool to pry around the edge of the phone.

Pry carefully around the card slots.

Slowly pull up from the right side of the screen like opening a book.

The plastic piece for the power button may fall out. Set it aside for reassembly.

Use the plastic spudger to peel the foam adhesive around the camera away from the back plate.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 4 other contributors

                    Caleb Kelsay

Member since: 10/14/2014

590 Reputation

                                      1 Guide authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       Cal Poly, Team 4-48, Amido Fall 2014                        

                                                  Member of Cal Poly, Team 4-48, Amido Fall 2014 



                    CPSU-AMIDO-F14S4G48                     


                                            5 Members                     


                                            17 Guides authored

deancvijic90 - Nov 12, 2016

what is the black ribbon antenna on the front

Introduction#

What you need#

Team#

Introduction

What you need

Team