Htc One Max Fingerprint Sensor Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          15 minutes            

Sections

2

• Back Case
• 4 steps
• Fingerprint Sensor
• 1 step

Flags

0

• BackHTC One Max

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Case               

• Lift back cover while pressing highlighted release switch towards the center of the phone.

Lift back cover while pressing highlighted release switch towards the center of the phone.

1024

Step 2

• Remove the four white stickers in each corner that cover the Tri-Wing screws.
• Remove the white sticker near the buttons that control the volume.
• Remove the white sticker near the SIM card.
• Remove the big white sticker with the bar-code in the center of the phone.

Remove the four white stickers in each corner that cover the Tri-Wing screws.

Remove the white sticker near the buttons that control the volume.

Remove the white sticker near the SIM card.

Remove the big white sticker with the bar-code in the center of the phone.

Step 3

• Remove the thirteen Tri-Wing Y00 screws (Upper & Lower screws are 5 mm length, middle screws are 3.8 mm length) from the back case.
• Disconnect the cable near the volume buttons.

Remove the thirteen Tri-Wing Y00 screws (Upper & Lower screws are 5 mm length, middle screws are 3.8 mm length) from the back case.

Disconnect the cable near the volume buttons.

Step 4

• Use the small plastic opening tool to pry between the screen and the rear case.

Use the small plastic opening tool to pry between the screen and the rear case.

Step 5

              Fingerprint Sensor               

• Use Tweezers to disconnect the ribbon cable connecting the fingerprint sensor to the motherboard.
• When replacing the fingerprint sensor, make sure the ribbon cable snaps into the port on the motherboard.

Use Tweezers to disconnect the ribbon cable connecting the fingerprint sensor to the motherboard.

When replacing the fingerprint sensor, make sure the ribbon cable snaps into the port on the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 

                    Andrey Sklyar                     

Member since: 09/23/2014

452 Reputation

                                      2 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges                           

Team

                       USF Tampa, Team 11-3, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 11-3, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S11G3                     


                                            4 Members                     


                                            7 Guides authored