Htc One Max Back Case Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          5 minutes            

Sections

1

• Back Case
• 4 steps

Flags

0

• BackHTC One Max

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Case               

• Lift back cover while pressing highlighted release switch towards the center of the phone.

Lift back cover while pressing highlighted release switch towards the center of the phone.

1024

Step 2

• Remove the four white stickers in each corner that cover the Tri-Wing screws.
• Remove the white sticker near the buttons that control the volume.
• Remove the white sticker near the SIM card.
• Remove the big white sticker with the bar-code in the center of the phone.

Remove the four white stickers in each corner that cover the Tri-Wing screws.

Remove the white sticker near the buttons that control the volume.

Remove the white sticker near the SIM card.

Remove the big white sticker with the bar-code in the center of the phone.

Step 3

• Remove the thirteen Tri-Wing Y00 screws (Upper & Lower screws are 5 mm length, middle screws are 3.8 mm length) from the back case.
• Disconnect the cable near the volume buttons.

Remove the thirteen Tri-Wing Y00 screws (Upper & Lower screws are 5 mm length, middle screws are 3.8 mm length) from the back case.

Disconnect the cable near the volume buttons.

Step 4

• Use the small plastic opening tool to pry between the screen and the rear case.

Use the small plastic opening tool to pry between the screen and the rear case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.                                             

Author

                                      with 7 other contributors 

                    Andrew Keller                     

Member since: 09/23/2014

1,131 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       USF Tampa, Team 11-3, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 11-3, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S11G3                     


                                            4 Members                     


                                            7 Guides authored                     

omair - Feb 23, 2015

Reply

any idea where i can purchase that back case?

khaydin - Jun 19, 2015

Reply

The “Tools” section of the guide lists a Y0 screwdriver as required but in the steps it says Y1. Now I have a Y0 screwdriver i can’t do anything with and i have to order a Y1. Hopefully that is accurate.

khaydin - Jun 27, 2015

Soooo… unless your HTC One MAX is completely different from the Sprint one i’m trying to replace the back on, both the Y0 and Y1 screw drivers are WRONG for this phone. They are both a bit too big to work on the screws. Now I’ve bought TWO screw drivers from you guys that were incorrect. Guess i’m gonna need to go out and buy a tri-wing screw driver set.

Leonturner21 - Nov 23, 2015

You need a #Y00 which is smaller then a #Y0 and #Y1 .

The site tells you to use a #Y00 and it does work for any HTC One Max