Htc Flyer Back Cover Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          1 - 2 minutes

Sections

Back Cover
4 steps

Flags

BackHTC Flyer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Apply pressure along the bottom of the white panel containing the camera and push upwards.
It may take some effort, but it will smoothly slide off.

Apply pressure along the bottom of the white panel containing the camera and push upwards.

It may take some effort, but it will smoothly slide off.

1024

Step 2

Unscrew the four of 3.5mm Torx T5 screws that run along the sides of the exposed innards.
All screws in the device will use the Torx T5 screwdriver, so keep it handy.

Unscrew the four of 3.5mm Torx T5 screws that run along the sides of the exposed innards.

All screws in the device will use the Torx T5 screwdriver, so keep it handy.

Step 3

Remove the black protective piece of plastic by sliding it upwards.
Remove the two 3.5mm Torx #5 screws holding the protective plastic down on along the sides.
A center 3.5mm Torx screw will be covered by “VOID” sticker.
Either remove the sticker or jam the screwdriver into the screw, and remove the screw.
Remove the protective panel by sliding it upwards.

Remove the black protective piece of plastic by sliding it upwards.

Remove the two 3.5mm Torx #5 screws holding the protective plastic down on along the sides.

A center 3.5mm Torx screw will be covered by “VOID” sticker.

Either remove the sticker or jam the screwdriver into the screw, and remove the screw.

Remove the protective panel by sliding it upwards.

Step 4

Before removing the back cover, apply some scotch tape to the volume buttons to prevent them from falling out of the back panel.
Use a plastic opening tool to lever up the top half of the cover.
Lift the back panel up and remove it from the device.

Before removing the back cover, apply some scotch tape to the volume buttons to prevent them from falling out of the back panel.

Use a plastic opening tool to lever up the top half of the cover.

Lift the back panel up and remove it from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors

                    Justin Funk

Member since: 10/07/2014

473 Reputation

                                      3 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       USF Tampa, Team 8-5, Leahy Fall 2014                        

                                                  Member of USF Tampa, Team 8-5, Leahy Fall 2014 



                    USFT-LEAHY-F14S8G5                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team