Htc Evo 3D Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          7 minutes

Sections

Speaker
6 steps

Flags

BackHTC Evo 3D
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Speaker

Remove the outer casing of the phone with your hands by prying and lifting at the latch.

Remove the outer casing of the phone with your hands by prying and lifting at the latch.

1024

Step 2

Remove the battery with your hands, lifting at the marked area.
Remove the SD card by pulling down on the bottom of the card.

Remove the battery with your hands, lifting at the marked area.

Remove the SD card by pulling down on the bottom of the card.

Step 3

Remove the four T5 screws using the cooresponding screwdriver.
Remove the two J000 screws using the cooresponding screwdriver.

Remove the four T5 screws using the cooresponding screwdriver.

Remove the two J000 screws using the cooresponding screwdriver.

Step 4

With the battery removed, the inner case of the phone can now be removed.
Using the plastic opening tool, pry the inner case off at the marked area. Continue prying around the entire perimeter of the phone.
This will remove the inner case, and allow access into the inner portion of the phone.
The marked part in the second photo is the speaker.

With the battery removed, the inner case of the phone can now be removed.

Using the plastic opening tool, pry the inner case off at the marked area. Continue prying around the entire perimeter of the phone.

This will remove the inner case, and allow access into the inner portion of the phone.

The marked part in the second photo is the speaker.

Step 5

The speaker can be loosened from its glue with the spudger.
Pry from the bottom with constant pressure to loosen one end of the speaker.
When the speaker is sufficiently loosened, completely remove it by grabbing it with the precision tweezers.

The speaker can be loosened from its glue with the spudger.

Pry from the bottom with constant pressure to loosen one end of the speaker.

When the speaker is sufficiently loosened, completely remove it by grabbing it with the precision tweezers.

Step 6

With the old speaker removed, insert the new speaker in the same place.
When reinserting the new speaker, be sure that the golden contacts (As previously marked) are facing up.

With the old speaker removed, insert the new speaker in the same place.

When reinserting the new speaker, be sure that the golden contacts (As previously marked) are facing up.

To reassemble your device, follow these instructions in reverse order but with a new speaker.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    James Burke

Member since: 08/26/2015

245 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 14-20, Meier Fall 2015                        

                                                  Member of USF Tampa, Team 14-20, Meier Fall 2015 



                    USFT-MEIER-F15S14G20                     


                                            5 Members                     


                                            10 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team