Htc Desire 826 Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          45 minutes - 1 hour            

Sections

2

• Battery
• 4 steps
• Motherboard
• 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackHTC Desire 826

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Battery               

• Find a seam in the back of the device.
• Insert the plastic spudger into the seam and pry off the back panel.
• There will be glue, so keep prying until it comes off or you may need to heat up the edges of the device to loosen the adhesive with the iOpener.

Find a seam in the back of the device.

Insert the plastic spudger into the seam and pry off the back panel.

There will be glue, so keep prying until it comes off or you may need to heat up the edges of the device to loosen the adhesive with the iOpener.

1024

Step 2

• Remove the 4.0 mm screw above the battery with a T5 Torx screwdriver.
• Remove the metal bracket with the tweezers.

Remove the 4.0 mm screw above the battery with a T5 Torx screwdriver.

Remove the metal bracket with the tweezers.

Step 3

• Disconnect the battery cable from the motherboard with the tweezers.

Disconnect the battery cable from the motherboard with the tweezers.

Step 4

• Lift the battery with a plastic spudger and remove it from the device.

Lift the battery with a plastic spudger and remove it from the device.

Step 5

              Motherboard               

• Remove the three 4.0 mm T5 Torx screws connected to the motherboard.

Remove the three 4.0 mm T5 Torx screws connected to the motherboard.

Step 6

• Disconnect the ribbon cable from the motherboard by flipping up the locking tab with a spudger and pulling out the cable with your fingers.
• Lift the motherboard out of the frame, using a spudger to help pick up one of the edges.

Disconnect the ribbon cable from the motherboard by flipping up the locking tab with a spudger and pulling out the cable with your fingers.

Lift the motherboard out of the frame, using a spudger to help pick up one of the edges.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Savannah Nichole Harris                     

Member since: 09/17/2020

85 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       The Citadel Military College of South Carolina, Team S3-G18, Eggleston Fall 2020                        

                                                  Member of The Citadel Military College of South Carolina, Team S3-G18, Eggleston Fall 2020 



                    CMCSC-EGGLESTON-F20S3G18                     


                                            3 Members                     


                                            6 Guides authored